Philips L06.1E AA L06.1E Mechanical Instructions Assy / Board Removal, Mains Switch/LED Panel

EN 10	4.	L06.1E	Mechanical Instructions
4.4 Assy / Board Removal			4.4.3 Small Signal Board (SSB)

Sometimes, it can be necessary to swap a complete assy or Printed Wiring Board (PWB). How that can be done is explained below.

4.4.1Top Control & Side I/O Assy/Panel

G_16350_046.eps 060406

Figure 4-3 Top control & Side I/O assy/panel

1.Remove the two fixation screws that hold the panel (see Figure “Top control & Side I/O assy/panel”).

2.Pull the board backwards and remove it from the TV set.

3.Remove, if necessary, all the connectors from the board.

4.4.2Mains Switch/LED Panel

1 1

2

3

3

G_16350_064.eps 070406

Figure 4-4 Mains Switch / LED panel

1.Release the two fixation clamps [1] by pushing them backwards and upwards (see Figures above).

2.Pull the complete assy backwards [2].

3.If the board has to be removed, release the two clamps at the sides of the bracket and lift the panel out [3].

G_16350_048.eps 060406

Figure 4-5 SSB removal from chassis

G_16350_049.eps 060406

Figure 4-6 SSB removal from bracket

1.Release the fixation clamp (see Figure “SSB removal from chassis”) by pushing it backwards.

2.Take the complete SSB out.

3.If the board has to be removed, release the two clamps at the sides of the bracket and lift the panel out (see Figure “SSB removal from bracket”).