Philips Understanding IFPLL in CRT Television Service Modes and Error Codes

EN 18 5. L06.1E Service Modes, Error Codes, and Fault Finding

5.8.2SAM Menu Structure

The SAM Menu structure of the L06.1E AA is different from that of the ES1. Some of the menu items that were in the main menu of the ES1 are now in the submenu. The following table shows the structure of the SAM menu of the L06.1E AA.

Table 5-4 SAM menu structure

			Example of
			SAM
	SAM		Submenu
	Submenu	SAM Submenu	values /
SAM Main Menu	level 1	level 2	settings	Explanation of menu items
Clear			Yes	Clear. Erases the contents of the error buffer. Select the CLEAR menu item and press the CURSOR RIGHT key. The
				content of the error buffer is cleared.
Options	OP1			Options. Used to set the option bits. See “Options” in the Alignments section for a detailed description.
	OP2
	OP3
	OP4
	OP5
	OP6
	OP7
Tuner	IFPLL			Tuner. Used to align the tuner. See “Tuner” in the Alignments section for a detailed description.
	AGC
RGB Align	AKB		Off / On	RGB Align > White Tone. Used to align the white tone. See “RGB Align > White Tone” in the Alignments section for a
				detailed description.
	White Tone	Cool
		Normal
		Warm
		BlackL Offset R
		BlackL Offset G
	CL		7
Geometry	Horizontal	HP	8	Geometry. Used to align the Geometry. See “Geometry” in the Alignments section for a detailed description.
		HB	9
		HSH	33
		EWW	23
		EWP	26
		EWT	31
		UCP	41
		LCP	34
	Vertical	SBL		Note: If the TV set is switched to 50 Hz/double lines (i.e. not Pixel Plus/100 Hz) only “VS” is shown in the menu.
		VS	42
		VSH	26
		VAM	25
		VSC	21
Audio	AF-M		250	Audio. No audio alignment is necessary for this television set.
	A2-T		400
	AT		2
NVM Editor	ADR		0x0001 1	NVM Editor. Can be used to change the NVM data in the television set.
	VAL		0x0000 0
	Store
Compair	Compair			ComPaIr. In other TV sets, this menu item can be used to switch the television to “In System Programming” (ISP) mode,
				for software uploading via ComPair. In the L061E AA, however, a different system is used: IAP. Caution: When this
				mode is selected without IAP connected, the TV will be blocked. Remove the AC power to reset the TV.
	IAP			IAP. This tool is used instead of Compair (Compair is not implemented in this TV set).