Philips BDL4251V user manual Remote control numbering function, Component Video

User Manual BDL4251V

NOTE 3: “PIP”, “POP” and “SIDE BY SIDE”

The following table shows the combination of signal inputs under which the “PIP” and “POP” modes function. These modes do not function, however, when the screen size is “CUSTOM” or “REAL”.

					SUB
		HDMI	DVI-D	VGA	COMPONENT	S-VIDEO	VIDEO
	HDMI						
	DVI-D							: Supported
MAIN	VGA							: Not supported
	COMPONENT						
	S-VIDEO						
	VIDEO						

Press the “PIP ON/OFF” buttons on the remote control to change between “PIP”, “POP” and “SIDE BY

SIDE” mode as shown in the diagram below.

PIP	POP	SIDE BY SIDE	SIDE BY SIDE FULL
		ASPECT	OFF

“PIP”, “POP” mode resolution (Reference)
PIP SIZE	SMALL
	MIDDLE
	LARGE
POP SIZE

:450 dots X 338 dots

:675 dots X 450 dots

:900 dots X 675 dots

:450 dots X 338 dots

< Remote control numbering function >

By connecting multiple BDL4251V monitors using RS232C cables, you can control any one monitor or all the monitors by one remote controller.

1.Assign arbitrary ID number to each of multi-connected BDL4251V monitors using MONITOR ID. ID numbers 1 to 26 are selectable.

It is recommended to assign sequential ID numbers from 1 and up.

2.The remote control mode of the first BDL4251V monitor is set to PRIMARY and those of the other monitors are set to

SECONDARY.

3.When you direct the remote controller at the remote control signal sensor of the PRIMARY monitor and press the DISPLAY button on the remote controller, the ID selection OSD appears at the upper left of the screen.

ID number of the currently viewed monitor

Select the ID number of the monitor you want to control using the +/- button on the remote controller.

The ID of the monitor you want to control is displayed at the upper left of its screen. By selecting ALL, you can control all the multi-connected monitors.

4.Direct the remote controller at the remote control signal sensor of the PRIMARY monitor. OSD appears on the monitor having the ID number you selected.

NOTE:

When the ID selection OSD is being displayed on the PRIMARY monitor, press the DISPLAY button on the remote controller again to cancel the ID selection OSD and then control the monitor you selected.

HINT:

If you set the remote control mode wrongly and remote control operation becomes unavailable, press MENU button on the control panel of the monitor to display the OSD screen and change the remote control mode using ADVANCED OPTION. By pressing

and holding down the DISPLAY button on the remote control for 5 seconds or longer, the remote control mode is initialized to

NORMAL.

42