Philips 26PFL3403/94 Use more of your TV, Use TV menus, Adjust picture and sound settings

Page 16

7Use more of your TV

Use TV menus

On-screen menus help you to install your TV, adjust picture and sound settings and access other features.This section describes how to navigate the menus.

Access the main menu

1 Press MENU.

»The main menu appears.

Main Menu

Overview

Exit

Picture

Sound

Installation

Features

The main menu offers the following submenus:

[Picture]: Select this menu to adjust picture settings.

[Sound]: Select this menu to adjust sound settings.

[Installation]: Select this menu to install and rearrange channels and set preferences.

[Features]: Select this menu to access additional functions.

2 Press EXIT to exit.

Adjust picture and sound settings

Adjust picture settings

1 Press MENU.

2 Select [Picture].

3 Press OK.

»The [Picture] menu appears.

Main Menu

Picture

Return

Smart Picture

Personal...

Brightness

 

 

 

 

Colour

 

 

 

 

Contrast

 

 

 

 

Tone

Normal...

Sharpness

 

 

 

 

Noise reduction

Low...

Other settings

...

 

 

 

4 Press or to select a setting.

5 Press or to adjust the settings.

Description of picture options

[Smart Picture]: Sets your TV to a pre- defined picture setting. Press or to select a setting for the channel or source you are watching.You can access the list of pre-defined picture settings directly by pressing SMART MODE on your remote control.

Note

Smart mode is not available for VGA (PC) mode.

[Brightness]: Adjusts the intensity and details of dark areas.

[Colour]: Adjusts color saturation.

[Contrast]: Adjusts the intensity of bright areas, keeping dark areas unchanged.

[Tone]: Adjusts the color balance in an image.

16EN

Image 16
Contents Register your product and get support at 26PFL3403/94 Page Contents Warranty Pixel characteristicsKoninklijke Philips Electronics N.V. All rights reserved Compliance with EMFSafety Screen care Environmental careDisposing of your used product Recycling your packagingSide controls and indicators Back connectorsYour TV TV overviewRemote control Get started Position the TVWall mount the TV Use a Kensington lockConnect the power cord Disconnect the TV from the powerConnect the antenna cable BatteriesSwitch on your TV Install channels Automatically install channelsManually install channels Rearrange channelsSwap a channel number Change a channel nameDelete a channel Define a list of favorite channelsSwitch your TV on/off or to standby Switch channelsAccess your favorite channels Use your TVAdjust volume Display a list of channelsDisplay status information Watch connected devicesAdjust picture and sound settings Access the main menuAdjust picture settings Use more of your TVAdjust sound settings Use smart picture settingsChange picture format Adjust the frequency range Use smart sound settingsDescription of sound options Use timers Automatically switch the TV to standby SleeptimerSet delay after which the TV goes into standby mode Set a time at which the TV goes into standby modeActivate the timer Reset your PIN codeUse parental control Automatically turn on the TV from standbyLock a channel or source Unlock a channel or sourceLock TV buttons Unlock the TV buttonsLock the Installation menu Unlock the Installation menuCustomize your TV Unlock the Time menuChannel or source.To enable the mode, press , , or OK Configure sourcesUse your TV as a PC monitor Select your connection qualityHdmi Highest quality Component Y Pb Pr High qualityComposite Basic quality Composite video/audio cable yellow/red/whiteTroubleshooting Product information