Philips 26PFL3403/94 user manual Safety

Page 5

2 Important

Read this user manual before you start to use this product.

Pay close attention to this section and follow the safety and screen care instructions.The product warranty does not apply if damage is caused by failing to follow these instructions.

The model and serial number of your TV can be found on the back of the TV as well as on the packaging.

Safety

Two people are required to lift and carry a TV that weighs more than 25 kilos (55lb). Improper handling of the TV can result in serious injury.

If transporting the TV in low temperatures (less than 5°C), open the box and

wait until the TV matches the ambient temperature of the room before unpacking.

To avoid short circuit, do not expose the TV, remote control or remote control batteries to rain or water.

To avoid risk of fire or electric shock, do not place the TV, remote control or remote control batteries near naked flame sources (e.g., lighted candles) and other heat sources including direct sunlight.

Do not place vessels filled with water on top of or near to the TV. Spilling water into the TV can result in electric shock. If you spill water into the TV, do not operate the TV. Immediately disconnect the TV from the power and have the TV checked by a qualified technician.

Do not install the TV in a confined space such as a bookcase. Leave a space of

at least 10cm (four inches) around the

TV for ventilation. Be sure air flow is not obstructed.

If placing the TV on a flat, solid surface be sure to use only the supplied stand. Do not move the TV if the stand is not properly screwed to the TV.

Wall mounting of the TV should only be performed by qualified personnel.The TV must only be mounted on an appropriate wall bracket and on a wall that can safely hold the weight of the TV. Improper wall mounting can result in severe injury or damage. Do not attempt to wall mount the TV yourself.

If the TV is mounted on a swivel base or swivel arm, ensure no strain is placed on the power cord when the TV is swivelled. Strain on the power cord can loosen connections and cause arcing or fire.

Disconnect the TV from the mains and antenna before lightning storms. During lightning storms do not touch any part of the TV, mains cord or antenna cable.

Be sure that you have full access to the mains cord for easy disconnection of the TV from the mains.

When disconnecting the TV from the mains, be sure to:

1 Turn off the TV, then the mains power (if available).

2 Unplug the mains cord from the mains socket outlet.

3 Unplug the mains cord from the power connector at the back of the TV. Always pull the mains cord by the plug. Do not pull the mains cord.

EN

EN 5

Image 5
Contents Register your product and get support at 26PFL3403/94 Page Contents Pixel characteristics WarrantyKoninklijke Philips Electronics N.V. All rights reserved Compliance with EMFSafety Environmental care Screen careDisposing of your used product Recycling your packagingBack connectors Side controls and indicatorsYour TV TV overviewRemote control Position the TV Get startedWall mount the TV Use a Kensington lockDisconnect the TV from the power Connect the power cordConnect the antenna cable BatteriesSwitch on your TV Automatically install channels Install channelsManually install channels Rearrange channelsChange a channel name Swap a channel numberDelete a channel Define a list of favorite channelsSwitch channels Switch your TV on/off or to standbyAccess your favorite channels Use your TVDisplay a list of channels Adjust volumeDisplay status information Watch connected devicesAccess the main menu Adjust picture and sound settingsAdjust picture settings Use more of your TVChange picture format Use smart picture settingsAdjust sound settings Description of sound options Use smart sound settingsAdjust the frequency range Automatically switch the TV to standby Sleeptimer Use timersSet delay after which the TV goes into standby mode Set a time at which the TV goes into standby modeReset your PIN code Activate the timerUse parental control Automatically turn on the TV from standbyUnlock a channel or source Lock a channel or sourceLock TV buttons Unlock the TV buttonsUnlock the Installation menu Lock the Installation menuCustomize your TV Unlock the Time menuConfigure sources Channel or source.To enable the mode, press , , or OKSelect your connection quality Use your TV as a PC monitorHdmi Highest quality Component Y Pb Pr High qualityComposite video/audio cable yellow/red/white Composite Basic qualityTroubleshooting Product information