Philips 64PP9751 manual Surround Sound, Connect both external, Place the speakers so

SOUND MENU CONTROLS (CONTINUED)

	SURROUND SOUND
	y adding optional external
	Bspeakers to the PTV's sound
	system, you can create the feeling
	of reflected sound that surrounds
	you at a movie theater or concert
	hall.
1	Connect both external
	speakers to the speaker wire
	terminals on the PTV.
	Recommended speakers: 8 ohm, 15
	watt minimum. Be sure the (+) and
	(-) speaker wires are connected to
	the correct R(ight) and L(eft)
	speaker terminals on the TV.
2	Place the speakers so the

REAR SURROUND SOUND

SPEAKER TERMINALS

SUBWOOFER OUTPUT Use the Subwoofer Output (RCA plug connector) to send the subwoofer audio channel signal (at line level) to an optional external powered Subwoofer speaker. The Subwoofer audio signal is for the playback of only the lowest frequency notes (under 100 Hz).

SMART

HELP

BACK OF PTV

Remember,

Surround Sound will not work with only one speaker

connected; or with monaural audio material (unless Variable Audio Surround control is turned ON - see section below).

viewing area is between the PTV

and the rear surround speakers.

(See overhead view drawing.)

3 Turn PTV ON and place the

+ - + - PTV

SUBWOOFER

STEREO control to the "STEREO

IF AVAILABLE" (✔) position.

After setup whenever a stereo

signal is received the audio will be

heard in Surround Sound.

VARIABLE AUDIO OUTPUT

he PTV's Variable Audio

REAR SURROUND SOUND SPEAKERS

Note: The rear Surround Sound speakers will not be heard at the same volume level as the front TV speakers. It is intended for the rear speakers to give a background noise effect which requires a lower volume level than the TV's front speakers.

2

REAR SPEAKER REAR SPEAKER

PRIMARY VIEWING AREA

TOutput jacks can also be used

for Surround Sound. Once they are

connected to an external hi-fi

system its speakers can be used for

the playback of Surround Sound.

1 Connect the R(ight) and L(eft)

VARIABLE AUDIO OUT jacks

on the PTV to the R and L Audio

Input jacks on your amplifier or

sound system.

2 Turn PTV ON and place the

VARIABLE AUDIO OUTPUT on

screen control to the SURROUND

(✔) position. (Sound Menu 3 of 3).

Note:This will change the

Left/Right channel audio line level

signal at the Audio Output jacks to

the same signal found at the PTV's

Surround Sound Speaker terminals.

				1	BACK OF PTV
SOUND MENU
VARIABLE AUDIO OUTPUT
EXIT		MORE...
		VARIABLE AUDIO OUTPUT
		3 OF 3
		STEREO
		SURROUND		VARIABLE AUDIO
		EXIT		OUTPUT JACKS
				AUDIO
				INPUT JACKS
DN				R	L
2			mute
			channel	AUX/TV INPUT
		HDR PTV
			+
Menu		Source
			volume	PHONO INPUT
			+
	ok
	Exit
3/5	INFO	A/CH	2

AUDIO SYSTEM SPEAKERS USED AS REAR

SURROUND SOUND SPEAKERS

31