Sylvania DVR90VG manual Installing batteries in the remote control, Using a remote control

Page 12

Before you start

Functional overview (cont’d)

Installing batteries in the remote control

Install two “AA” size batteries (supplied), matching their polarity to those indicated inside battery compartment of the remote control.

1

2

3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please follow the instruction

below:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together. Although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing used batteries, please comply with governmental regulations or public rules for environmental protection that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

Using a remote control

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor of the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall-off of the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

-Line of sight: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

Within about 23feet (7m)

 

30°

Remote

30°

 

control

 

The VCR / DVD recorder switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which component you wish to operate with [OUTPUT SELECT].

VCR MODE

Press [VCR] on the remote control. (Verify that the VCR indicator is lit.)

DVD MODE

Press [DVD] on the remote control. (Verify that the DVD indicator is lit.)

Note:

•Pressing only [OUTPUT SELECT] on the front panel DOES NOT switch the mode of the remote control. You MUST select the correct mode on the remote control.

•You cannot switch to another mode (DVD or VCR) during in the timer-standby mode.

•Pressing [REC/OTR] (DVD) or [REC/OTR] (VCR) on the remote control switches immediately its respective mode so that you can start recording directly on the appropriate media.

 

OUTPUT SELECT button

 

 

s B

 

 

VCR button

 

 

DVD button

OUTPUT SELECT

 

VCR s

BDVD

DVD indicator

 

 

VCR indicator

POWER

T-SET

 

OPEN/CLOSE

 

TIMER PROG.

.@/:

ABC

DEF

 

1

2

3

 

GHI

JKL

MNO

CH

4

5

6

 

PQRS

TUV

WXYZ

VIDEO/TV

7

8

9

 

DISPLAY

SPACE

CLEAR

SETUP

 

0

 

 

TOP MENU

MENU/LIST

RETURN

ENTER

REC/OTR

VCR

DVD

REC/OTR

REC SPEED

 

PLAY

 

x1.3/0.8

SKIP

PAUSE

SKIP

SLOW

CM SKIP

STOP

SEARCH

DUBBING

ZOOM

AUDIO

 

10EN

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Supplied Accessory Changing the Setup menu VCR functions Others EspañolRecordable disc EditingIDVD+R/+RW discs can be played back only on this unit Number inside the globe refers to region of the worldAfter you have completed connections Functions AttributesAfter all recordings, finalize your disc Select any blank line with K / L and press EnterHints for DVD Recording Play Back DVD-R or DVD-RWPrecautions Laser SafetyBefore you start Make your contribution to the environmentPrecautions cont’d Before youInstallation Location Avoid the Hazards of Electrical Shock and FireMoisture Condensation Warning About CopyrightMaintenance With an AM radioDolby Digital Recording Table of contents Features RecordingEditing CompatibilityFront Panel Rear PanelRemote Control Functional overview cont’dInstalling batteries in the remote control Using a remote controlVCR / DVD recorder switching Either side of the center approx feet 5m withinSetup menus DVD mode First DVD Display menuFront Panel Display Guide Display messageFunctions Others Español Plug in the AC power cord of this unit ConnectionsConnection to a TV Audio OUT Video OUTSelect on using K / L , then press Enter Select Yes using / B , then press EnterConnection to a TV cont’d Connection to a cable box or satellite boxConnection to an Audio System Audio OUTDigital Audio OUT Getting started Easy DVD recordingInstructions continue on the next page. EN Before you startEasy DVD recording cont’d Select Record Recording Desired On DVD Speed Channel DiscInitial setting Channel settingGetting channels automatically Channel setting cont’d Press Setup Using K / L, select Channel. Press EnterUsing K / L, select Manual Preset. Press Enter Adding / deleting channelsUsing K / L, select TV Audio Select. Press Enter Using K / L, select Stereo or SAP. Press EnterSelecting the TV stereo or SAP SAP Secondary Audio ProgramSetting the clock Auto Clock SettingPress Setup Using K / L, select Clock. Press Enter Press Setup to exit Press Power to turn off the unitSetting the clock cont’d Manual Clock SettingChanging the Setup menu Playing discsSetting the Daylight Saving Time Using K / L, select Daylight Saving Time. Press EnterUsing K / L, select TV Aspect. Press Enter Selecting the TV aspect ratioRecording Information on DVD recordingInformation Recordable discInformation on DVD recording cont’d Restrictions on recordingMaking discs playable on other DVD player Finalize Information on copy controlFormatting a disc Choosing the recording format of a blank discSetting for Auto Chapter Formatting a disc cont’dReformatting a disc Basic recording Disc tray guideOne-touch Timer Recording First DVD Turn on the unit and load a recordable discMake sure that the TV input is set on the unit Timer Recording Timer Recording cont’d Hints for Timer Recording Priority of overlapped settingsChanging the Setup menu VCR Settings for an external source Connection to an external sourceSettings for an external source cont’d Setting a disc to protectChanging the Editing Setup menu VCR functions Recording from an external sourceUsing K / L, select Finalize. Press Enter Finalizing the discsDVD-RW only 36 ENPress Setup Using K / L, select Recording. Press Enter Using K / L, select ON. Press EnterFinalizing the discs cont’d Auto finalizeDubbing Mode Make sureDubbing Mode cont’d DiscsPlaying discs Information on DVD playbackBasic playback PlaybackMenu / List Start Connections Getting started Recording Playing discsBasic playback cont’d Playing MP3 / WMA discPress Play B to start play- back Playing discs using the Disc menu Playing back discs using the Title menuPause Special playback Resume playbackSkipping TV commercials during playback X40Special playback cont’d Rapid PlayStep by step playback Slow forward / Slow reverse playMarker Setup Using / B, select . Press EnterZoom During playback, press ZoomUsing Skip H / G Using DisplaySearch Title / Chapter searchSearch cont’d Track searchTime search Repeat/Random/Program playback Repeat playbackRandom play DisplaySwitching subtitles Repeat/Random/Program playback cont’dSelecting the format of audio and video Program playSwitching audio soundtrack Switching virtual surround systemDVD-RW VR mode Selecting a format of audio and video cont’dSwitching camera angles Using K / L, select OFF Type1 Natural effect Type1 or Type2Using / B, select Visual Noise ReductionEditing Information on disc editingEditing discs in Video mode Using K / L / / B, select the desired title. Press EnterUsing K / L, select Edit. Press Enter Deleting titlesEditing discs in Video mode cont’d Changing the Setup menu VCR functionsPutting names on titles Start Connections GettingSetting or clearing chapter markers Marker will be added or deletingEditing discs in VR mode Original Editing discs in VR mode Original cont’d Setting titles to protectUsing K / L, select Protect. Press Enter To exitYou can cancel the title-protecting feature Releasing titles from protectingStart Connections Getting started Recording Confirm the indication On OFF. Press EnterEditing discs in VR mode Playlist Editing discs in VR mode Playlist cont’d Dividing a titleUsing K / L, select Title Combining. Press Enter Using s / B, select Yes. Press EnterCombining titles Adding titles to a Playlist Deleting a PlaylistOthers Editing discs in VR mode Original / Playlist Using K /L, select Edit. Press EnterUsing K / L, select Delete. Press Enter Deleting parts of titlesEditing discs in VR mode Original / Playlist cont’d You StartReturn When you select Add at , a Confirmation window will appear. Playlist AddPlaylist Delete You cannot delete the first Chapter of each titleSetting pictures for thumbnails Changing the Editing Setup menu VCR functions OthersRecording Playing discs Picture for thumbnail will be set. PlaylistChanging the Setup menu Tour of the Setup menuSetup Items highlight is the default Contents Language setting Language setting cont’d Display settingSubtitle Language Default OFF Press Setup Using K / L, select Display. Press EnterDisplay setting cont’d Audio settingChanging Audio setting cont’d Settings for PCM Default 48kHzSettings for Dolby Digital Default Stream Press Setup to exitVideo setting Settings for Parental lock levelStill Mode Default Auto Using K / L, select the desired level. Press EnterSettings for Parental lock level cont’d Password has not been set yetPassword has been set already YesRecording and One-touch Timer Recording VCR functionsPlayback RecordingRecording and One-touch Timer Recording cont’d One-touch Timer RecordingIndex search Other operations Troubleshooting SymptomOthers RemedySymptom Remedy Or Setup toYou press OPEN/CLOSE a Troubleshooting cont’d Error message Cause Solution80 EN Disc MAY not workRF output switch Before you start Connections Getting startedEach time the RF output Panel displayGlossary Language codeFrequently Asked Questions SpecificationsGeneral TunerEspañol Fácil grabación de DVDSugerencia 1 Reproduzca el contenido grabado Sugerencia 2 Edite el disco grabadoReproducción con videograbadora Se hará una pausa de reproducción y se silenciará el sonido86 ES Grabación Grabación con temporizador de un toque OTRStop C Customer Service TelLimits and Exclusions Funai Corporation
Top Page Image Contents