Philips 55PP9753/17 IMPORTANT! Initial TV Setup, Using the TV Buttons, Using the Remote Control

Page 3

IMPORTANT! Initial TV Setup

When you turn on your TV for the first time it will prompt you to enter some setup information about Language preference and Channel program- ming. See page 6-7, “Using the Installation Features” in this Quick Use and Setup Guide for more information about these menus.

LanguageAutoprogram

Select your menu language with the cursor up/down.

Press the OK key on the remote control to confirm.

Using the TV Buttons

Your television has a set of buttons located on the front of the cabinet for use when the remote control is not needed or unavailable.

1 Press the Power button to turn the TV on.

2 Press the VOLUME + (up) button to increase the sound level or the VOLUME – (down) button to lower the sound level. Or use the buttons to navigate right or left when the on-screen menu is displayed.

3 Press the CHANNEL K (up) or L (down) button to select TV channels. Or use the buttons to navigate up and down when the on-screen menu is displayed.

Picture Sound Features Channels

TV

Settings

Demo

Install

Exit

5

4

5

To access the on-screen menu, press the MENU button. To navigate the menu, use the VOLUME + (up)/– (down) and CHANNEL K (up)/L (down) buttons to navigate the menu as described in the previous steps.

To remove the menu, Press CHANNEL Down to select Exit. Then press the MENU button,

2

4

 

4

Blue LED indicator

 

 

31

45

Using the Remote Control

Installing the Batteries

To load the supplied batteries into the remote:

1 Remove the battery compartment door on the back of the remote.

2 Place the batteries (2-AA) in the remote. Make sure the (+) and (–) ends of the batteries line up correctly (the inside of the case is marked).

3 Reattach the battery compartment door.

Be sure to point the remote at the Remote Sensor window on the front of the television when using it to operate the television.

3

Remote Control

(shown from the bottom)

1

HELPFUL HINT

When the batteries in your remote control run low, the remote control will send a “Battery low” command to the TV. The TV will then display a message on the screen reminding you to replace the batteries as soon as possible.

2

3

Image 3
Contents Cable TV ContentsPositioning the TV Making Basic Connections to the TVCable Box with RF IN/OUT Cable Box with A/V OutputsAntenna Installing the Batteries IMPORTANT! Initial TV SetupUsing the TV Buttons Using the Remote ControlRemote Control Buttons Using the On-screen Menu Using the Demo Mode Using the Installation FeaturesLanguage Mode control Press the Menu button on the remote control to showPress the Cursor Down button repeatedly until Install Press the Cursor Down button to select the InstallIntelliSense is selected Press the Cursor Down button to select SettingsPress the Cursor Right button to select General Press the Cursor Down button repeatedly until