Philips MCD2010 Get started, Turn on, Find the correct video input channel, Set the clock

In standby mode, press and hold PROG/ CLOCK SET for three seconds.

»» “CLOCK SET” scrolls on the display. Then the time format [24H] or [12H] is displayed.

Press / to select a time format. Press PROG/CLOCK SET to store the setting. »» The hour digits blink.

Turn on the unit.

Press FM.

»» [AUTO INSTALL -- PRESS PLAY --

STOP CANCEL] (press to start automatic installation, or press to cancel) is displayed.

4 Get started

Turn on

1 Press .

»» The unit switches to the last selected source.

Note

•• If no source is played within 15 minutes, the unit switches to standby mode.

•• If no operation is performed within 15 minutes in standby mode, the unit switches to Eco- power standby mode.

•• Press to switch the unit to the last source when it was turned off.

4 Press PROG/CLOCK SET to confirm the setup.

Note

•• The number key on the remote control is deactivated in this mode.

Store radio stations automatically

If no radio stations are stored, the unit can store radio stations automatically.

1

2

Demonstrate the unit’s features

1 In the standby mode, press until “DEMO ON” is displayed.

»» This system’s features are displayed one by one.

•To turn off the demonstration, press again.

Set the clock

The unit uses the 24-hour or 12-hour time format.

1

2

3 Press / to set the hour. Press PROG/ CLOCK SET to store the setting.

»» The minute digits blink.

3 Press .

»» The unit automatically stores radio stations with sufficient signal strength.

»» After all available radio stations are stored, the first stored radio station is broadcast automatically.

Find the correct video input channel

1 Turn on your unit.

2 Press DISC to select the disc source.

•Turn on the TV and switch to the correct video-in channel.

Note

•• See the user manual of your TV for how to switch between video-in channels.

14EN