Philips CCZ132AT Hooking Up The TV/VCR, Hook up your TV/VCR using one of the connections shown

Page 6

6 Hooking Up The TV/VCR

1

Hook up your TV/VCR using one of the connections shown.

A.

Hooking Up Your TV/VCR With a Cable Signal or Outdoor Antenna

Connect a Cable signal or an antenna to the ANT(enna) Jack.

ANT.

B.

Hooking Up Your TV/VCR With a Cable Box

To view any channel, set the TV/VCR to the Cable Box output channel (channel 03 or 04). Then, select channels at the Cable Box.

Connect the Cable signal to the IN Jack on the Cable Box.

Connect an RF coaxial cable (75- ohm, not supplied) to the OUT Jack

on the Cable Box and to the	OUT	IN
on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.

ANT.

C.

Hooking Up Your TV/VCR With an Indoor Antenna

To install a rod antenna (not sup- plied), push the stem of the antenna into the antenna hole on the top of the TV/VCR. Connect the antenna wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.

Rod Antenna

(not supplied)

ANT.

Image 6

Contents CCZ132AT CCW135AT Dear Philips Magnavox product owner For Customer UseFeatures Safety PrecautionsIntroduction Table of Contents Before Using the TV/VCR Hook up your TV/VCR using one of the connections shown Hooking Up The TV/VCRRod Antenna Crooked Pin Straight Pin Hooking Up The TV/VCR cont’dBent pin Cable PlugUsing the Swivel Base CCW135 only Turning On the TV/VCR Screen shown below will appearPress the Menu button. The screen shown below will appear Language Selection Press the PLAY/ button or the STOP/ button to selectEnglish or Español Spanish Press the STATUS/EXIT button Automatic Channel Setup Wait for the TV/VCR to set up ChannelsPress the Menu button Adding/Deleting Channels Programming of the channel you added or deleted will appearSetting the Clock Manual Clock SettingSetting the Clock cont’d Automatic PBS Channel Selection Wait for the TV/VCR to find the time Manual PBS Channel Selection NOW Searching flashes on the TV/VCR screen Daylight-Saving Time Time Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons Channel o/p Buttons Volume o/p ButtonsALT. CH Alternate Channel Button Mute ButtonMore purple Adjusting the Picture ControlsMore brilliant SofterIf you select Status ON, then select Counter only on On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status OFFReminder Playing Recording Press the RECord/OTR button once to start recordingOne-Touch Recording OTRRerecording Tape Duplication Different brands of equipment may operate differentlyTimer Recording DailyTimer Recording cont’d Instructions continue onProgram the TV/VCR to record more than one year in advance ONE Time ProgramChecking or Clearing Timer Recordings Defeat Recording Follow the steps below to prevent accidental recordingSetting the Sleep Timer Menu Closed CaptionExample ScreenClosed Caption cont’d Standard Closed CaptionsHalf-screen text Volume Bar PRIM. SETUP. Then, press the F.FWD/B buttonRepeat Play Over again VCR SETUP, then press the F.FWD/B buttonB Repeat Play Insert a tape in the TV/VCR Press the Menu buttonRepeat Play cont’d Flashing a will become a flashing BReal-Time Counter Memory Automatic Operation Features Super High Speed Searching LP/SLP Playback OptionsForward and Reverse Searching SP/LP/SLP Viewing a Still PictureSpecifications GlossaryHelpful Hints Helpful Hints cont’d Limited Warranty Please contact Philips at French Speaking English SpeakingModel # Serial # Index Supplied Accessories