Philips CCC 133AT Hooking Up the TV/VCR, Hook up your TV/VCR using one of the connections shown

Page 6

6 Hooking Up the TV/VCR

1

Hook up your TV/VCR using one of the connections shown.

A.

Hooking Up Your TV/VCR With a Cable Signal or Outdoor Antenna

Connect a Cable signal or an antenna to the ANT(enna) Jack.

CCC133

ANT.

ANT.

B.

Hooking Up Your TV/VCR With a Cable Box

To view any channel, set the TV/VCR to the Cable Box output channel (channel 03 or 04). Then, select channels at the Cable Box.

C.

Hooking Up Your TV/VCR With an Indoor Antenna

To install a rod antenna (not sup- plied), push the stem of the antenna into the antenna hole on the top of the TV/VCR. Connect the antenna wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.

Connect the Cable signal to the IN Jack on the Cable Box.

Connect an RF coaxial cable (75-

 

 

ohm, not supplied) to the OUT Jack

 

 

on the Cable Box and to the

 

 

ANT(enna) Jack on the TV/VCR.

OUT

IN

CCC133

RF coaxial cable

(not supplied)

ANT.

ANT.

Rod Antenna

(not supplied)

CCC133

ANT.

ANT.

Image 6
Contents Color TV with built-in VCR This bolt of lightning indi- cates uninsulated material Dear Philips product ownerFor Customer Use Model No Serial NoReal-Time Counter Frame Advance Remote Control FeaturesSafety Precautions IntroductionTable of Contents TV/VCR Maintenance Battery SafetyUsing the Remote Control Replace the battery compartment lidRF coaxial cable Not supplied Hook up your TV/VCR using one of the connections shownHooking Up the TV/VCR Rod AntennaCrooked Pin Straight Pin Hooking Up the TV/VCR cont’dBent pin Cable PlugYou cannot set up channels if you are using a Cable Box Turning On the TV/VCRPress the Menu button. The screen shown below will appear Language Selection Press the Menu buttonPress the STATUS/EXIT button Automatic Channel Setup Wait for the TV/VCR to set up channelsRepeat steps 3-4 to add or delete other channels Adding/Deleting ChannelsPress the PLAY/o button or the STOP/p button to select Programming of the channel you added or deleted will appearCable Box users must set the clock manually Setting the ClockManual Clock Setting Pages six-eightSetting the Clock cont’d Setting the Clock cont’d Automatic PBS Channel SelectionNOW Searching flashes on the TV/VCR screen Wait for the TV/VCR to find the timeManual PBS Channel Selection Use the Number buttons to select your PBS station PRIM. SETUP. Then, press the F.FWD/ B button Daylight-Savings TimePress the PLAY/ button or the STOP/ button to select Time Zone Front Panel ANTenna Jack AC Power CordRear Panel Connect your antenna or cable here. Details are on page sixRemote Control Buttons REWind/ Button Menu ButtonSTATUS/EXIT Button STOP/ ButtonAdjusting the Picture Controls Adjusting the Picture Controls cont’d Decrease IncreaseDecreased brightness If you select Status ON, then select Counter only on On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status OFFReminder ReminderPlaying Follow the steps below to play a tapeInsert a tape in the TV/VCR Recording To stop recording, press the STOP/ button Tape SpeedsOne-Touch Recording You cannot record if Defeat Recording is ON. Details are onTV/VCR is now in Line Input mode Rerecording Tape DuplicationTimer Recording DailyTimer Recording cont’d Timer Recording cont’d Program REVIEW, then press the F.FWD/B button Timer recording information for the program in the lowestWith the TV/VCR on, press the Menu button Gram Review and press the F.FWD/B buttonDefeat Recording Follow the steps below to prevent accidental recordingVCR SETUP, then press the F.FWD/B button Repeat PlayTV programming will appear while the tape is rewinding B Repeat Play Insert a tape in the TV/VCR Press the Menu buttonRepeat Play cont’d Real-Time Counter Memory Appear on the screenViewing a Still Picture Forward and Reverse Searching SP/LP/SLPSuper High Speed Searching LP/SLP Viewing a Slow Motion PictureSmartLock To block ratings, follow the steps belowSmartlock menu will appear Ratings are defined on Ratings will remain blocked even after a power failureSmartLock cont’d Example Specific Sub-ratingsTo change the access code, follow these steps Use the Number buttons to enter your old access codeRating Explanations VCR Program VCR Setup Caption Reminder Blue BackgroundSLEEP. Then press the REWind/s button or Sleep TimerPress the SLEEP/WAKE UP button FWD/B button to select 30 MINutes, 60 MINutesWake Up Timer Timer Sleep Wake UP TV on ON-TIMEVolume Bar Cast with closed captions, you may choose to set the VolumeClosed Caption ExampleMenu Screen Closed Caption cont’d Standard Closed CaptionsHalf-screen text Switching the Antennas FM RadioAutomatic Operation Features Helpful Hints Helpful Hints cont’d Glossary Specifications Renewed Index Supplied Accessories