Philips CCC 193AT, CCC 133AT owner manual Helpful Hints cont’d

Page 55

Helpful Hints (cont’d) 55

TV/VCR has no power.

•Connect the power plug to an AC (alternating current) outlet completely.

TV/VCR power shuts off after 15 minutes.

•To save energy, the TV/VCR will shut itself off after 15 minutes when it is on a channel that is not receiving a broadcast signal (for example, a station that has gone off the air for the night). This is normal.

TV/VCR does not have a picture.

•Adjust the antenna. Details are on page six.

•Adjust the TV/VCR picture controls. Details are on pages 24-25.

•Select an active channel.

TV/VCR has poor sound or no sound.

•Adjust the volume.

•Press the MUTE button to restore the volume.

Tape playback is poor or tape is destroyed.

•Adjust the tracking. Details are on page 53.

•If moisture has accumulated in your TV/VCR, keep the power on for at least two hours, but do not try to play a tape. Details are on page 54.

TV/VCR does not display closed captions.

•Make sure COUNTER ONLY is OFF. Details are on page 26.

•Make sure closed captioning is available for the program. Refer to the TV listings in your local newspaper.

Remote control does not operate TV/VCR.

•Aim the remote control directly at the TV/VCR’s remote sensor. Details are on pages five and 20.

•Remove all obstacles between the remote control and the TV/VCR.

•Inspect and replace the batteries in the remote control. Details are on page five.

Number buttons will not select channels above 69.

•Enter channel numbers as a two-digit number. If you want to select channels 100 and above, enter channel numbers as a three-digit number. Details are on page 22.

•If you are using an antenna, only channels 2-69 will be available. Details are on pages 10-11.

You can not insert a tape into the TV/VCR.

•Insert the tape window side up, with the record tab facing you.

•Make sure a tape isn’t already in the TV/VCR by pressing the STOP/EJECT button on the TV/VCR.

•Gently push on the center of the tape. Never force a tape into the TV/VCR.

•If you have set a timer recording and the TV/VCR power is off, the TV/VCR will eject the tape if the record tab is missing.

You can not remove the tape from the TV/VCR.

•Make sure the power plug is completely connected to an AC (alternating current) outlet.

•If a timer recording is programmed, turn on the TV/VCR power, then eject the tape. Be sure to insert a tape and turn off the TV/VCR power for the timer recording.

•Unplug the TV/VCR power cord for five minutes. Then, plug in the power cord again, then press the POWER button on the TV/VCR. If the tape does not eject, press the STOP/EJECT button on the TV/VCR three to five times. If the tape still does not eject, you may need to have an authorized servicer remove the tape.

TV/VCR ejects the tape when you try to start a recording.

•Make sure the tape has a record tab. Details are on page five.

The cylinder rotates when tape playback is stopped.

•To enable the quick play mechanism, the cylinder will rotate for about five minutes. This is normal. The quick play mechanism switches the tape mechanism from Stop to Play in just one second.

Page 54 Page 56
Image 55
Page 54 Page 56
Contents Color TV with built-in VCR Model No Serial No Dear Philips product ownerFor Customer Use This bolt of lightning indi- cates uninsulated materialIntroduction FeaturesSafety Precautions Real-Time Counter Frame Advance Remote ControlTable of Contents Replace the battery compartment lid Battery SafetyUsing the Remote Control TV/VCR MaintenanceRod Antenna Hook up your TV/VCR using one of the connections shownHooking Up the TV/VCR RF coaxial cable Not suppliedCable Plug Hooking Up the TV/VCR cont’dBent pin Crooked Pin Straight PinTurning On the TV/VCR You cannot set up channels if you are using a Cable BoxPress the Menu button. The screen shown below will appear Press the Menu button Language SelectionPress the STATUS/EXIT button Wait for the TV/VCR to set up channels Automatic Channel SetupProgramming of the channel you added or deleted will appear Adding/Deleting ChannelsPress the PLAY/o button or the STOP/p button to select Repeat steps 3-4 to add or delete other channelsPages six-eight Setting the ClockManual Clock Setting Cable Box users must set the clock manuallySetting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’dWait for the TV/VCR to find the time NOW Searching flashes on the TV/VCR screenManual PBS Channel Selection Use the Number buttons to select your PBS station Daylight-Savings Time PRIM. SETUP. Then, press the F.FWD/ B buttonPress the PLAY/ button or the STOP/ button to select Time Zone Front Panel Connect your antenna or cable here. Details are on page six AC Power CordRear Panel ANTenna JackRemote Control Buttons STOP/ Button Menu ButtonSTATUS/EXIT Button REWind/ ButtonAdjusting the Picture Controls Decrease Increase Adjusting the Picture Controls cont’dDecreased brightness If you select Status OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status ON, then select Counter only onReminder ReminderFollow the steps below to play a tape PlayingInsert a tape in the TV/VCR To stop recording, press the STOP/ button Tape Speeds RecordingYou cannot record if Defeat Recording is ON. Details are on One-Touch RecordingRerecording Tape Duplication TV/VCR is now in Line Input modeDaily Timer RecordingTimer Recording cont’d Timer Recording cont’d Gram Review and press the F.FWD/B button Timer recording information for the program in the lowestWith the TV/VCR on, press the Menu button Program REVIEW, then press the F.FWD/B buttonFollow the steps below to prevent accidental recording Defeat RecordingRepeat Play VCR SETUP, then press the F.FWD/B buttonTV programming will appear while the tape is rewinding Insert a tape in the TV/VCR Press the Menu button B Repeat PlayRepeat Play cont’d Appear on the screen Real-Time Counter MemoryViewing a Slow Motion Picture Forward and Reverse Searching SP/LP/SLPSuper High Speed Searching LP/SLP Viewing a Still PictureTo block ratings, follow the steps below SmartLockSmartlock menu will appear Example Specific Sub-ratings Ratings will remain blocked even after a power failureSmartLock cont’d Ratings are defined onUse the Number buttons to enter your old access code To change the access code, follow these stepsRating Explanations Blue Background VCR Program VCR Setup Caption ReminderFWD/B button to select 30 MINutes, 60 MINutes Sleep TimerPress the SLEEP/WAKE UP button SLEEP. Then press the REWind/s button orTimer Sleep Wake UP TV on ON-TIME Wake Up TimerCast with closed captions, you may choose to set the Volume Volume BarExample Closed CaptionMenu Screen Standard Closed Captions Closed Caption cont’dHalf-screen text FM Radio Switching the AntennasAutomatic Operation Features Helpful Hints Helpful Hints cont’d Glossary Specifications Renewed Index Supplied Accessories
Top Page Image Contents