SVZ142.comb 4/7/99 6:30 PM Page 11
●Before turning on your VCR, make sure there are batteries in the remote control and the VCR and TV are connected (see pages five - 10).
●You can not set up channels if you are using a Cable Box/DBS.
●The instructions on this page only work when you turn on the VCR for the first time. If there is a power failure or if the VCR is unplugged for more than one minute, you may need to repeat the instructions on this page.
Turning on Your VCR 11
2Turn on the TV.
1
Press the POWER button. The POWER light and the VCR/TV light will appear.
2
Turn on the TV. Set it to the same channel as the CH3/CH4 switch on the back of the VCR. The menu shown
below will appear.
LANGUAGE SELECT |
|
→ ENGLISH | [ON] |
ESPAÑOL |
|
3
Press the PLAY button or the STOP button to select ENGLISH or ESPAÑOL. [ON] will appear beside your choice.
4
Press the F.FWD button or the MENU button. TUNER SET UP will appear
TUNER SET UP
5
Press the MENU button, the F.FWD button, or the REWIND button to begin automatic channel setup.
TUNER SET UP will flash
(If you try to set up channels when there is no antenna or cable connected to the VCR, programming will appear to take place. Eventually, TUNER SET UP will appear
1
POWER | VCR/TV | EJECT |
1 2 3
4 5 6
7 8 9 CHANNEL
| SPEED | 0 | +100 |
|
|
| SLOW | QUICK- | SEARCH |
| |
| TIME | INDEX |
| ||
| FIND | 4 | |||
5 | MENU | DISPLAY | EXIT | COUNTER | |
|
| RESET | MEMORY | ||
REWIND | / PLAY | F.FWD | |||
RECORD |
| / STOP | PAUSE/STILL |
|
3
Helpful Hints
•If you do not see any