The programme edit functions
You can mark up to ten (10) individual scenes from exi- sting video recordings, transfer to the "Programme Edit" list of the video recorder, rearrange and afterwards
It is a prerequisite that your camcorder is equipped with a "Bus control" and has an hour, minute, second or single picture counter (time code counter).
The "Bus control" can be recognized by a 5 pin MEI socket or by a 2.5 mm Ø control socket (LANC control) on the camcorder.
In addition, you can control playback and fast wind functions of many camcorders with the corresponding control elements on the video recorder.
Connect the two units with the corresponding synchro- edit cable (socket Dor /on your video recorder).
The picture/sound signal is relayed via the input
sockets ©("E3") or ("E4") and »+ ¼ (sound input for "E3" and "E4") into the video recorder. The sockets are located at the front of the video recor- der behind a flap.
Observe the operating instructions for your camcorder. Make sure that the "correct" cassette without erase protect is placed in the video recorder.
!Switch on the television set and select the programme number for the video recorder.
"Switch the video recorder on and select the programme numbers of the connected picture/sound source ("E3" or "E4").
¤Switch on the camcorder. Insert the "correct" cassette. If the connected camcorder does not have a time code (see operating instructions of the cam- corder) then set the tape length counter of the camcorder to zero at the start of the tape.The "zero point" (Reference point for the section) can be sel- ected from any tape position.
$Press the lbutton on the remote control. The OSD page "MAIN MENU" appears on the screen. Select the line "A/V Edit".
Confirm with the Gbutton.
%The OSD page "EDIT MENU" appears on the screen. Select the "Programme edit" line. Confirm with the Gbutton.
&The OSD page "PROGRAMME EDIT" appears on the screen. The line "Edit scene" is active. Confirm with the Gbutton.
/Select the scene to be edited.
Switch to the OSD page "Player" with the ;button (for camcorder operation). Find the beginning of the scene on the camcorder which you want with the (button on the video recorder.
(Find the end of the scene on the camcorder, which you want to
button on the video recorder.
)Press the ¨button. The marked scene will be automatically accepted in the OSD page "PROGRAMME EDIT" (editing sequence).
Repeat steps / to ) until all the scenes required have been marked.
<: Quit with the lbutton. The OSD page "PROGRAMME EDIT" appears on the screen.
Note:
*All scenes are active and therefore marked with an
asterisk (*). You can only record active scenes. With the pbutton you can activate and then deac-
tivate each individual scene.
Rearranging individual scenes
Establish the sequence of the scenes in the editing sequence before
!Call up the OSD page "PROGRAMME EDIT". The line "Edit scene" is active.
Confirm with the Gbutton.
"The OSD page "PROGRAMME EDIT" (editing sequence) appears on the screen.
‚Select the scenes which you wish to relocate. Press the Gbutton.
¤Relocate the scene to the required position. Confirm with the Fbutton.
$Quit with the lbutton.
ENGLISH
35