Philips VRA601AT Before Using Your VCR, Removing the Plastic Cover from the Front Panel

Page 5

Before Using Your VCR 5

Removing the Plastic Cover from the Front Panel

A thin, plastic cover may protect the front panel of your VCR.

Before using the VCR, lift a corner of the plastic, then peel it off.

Putting Batteries in the Remote Control

1

Remove the battery compartment lid on the bottom of the remote control by sliding it in the direction of the arrow.

2

Place two AA batteries inside the battery compartment

with their + and – ends aligned as indicated.

3

Replace the battery compartment lid.

Erasure Prevention

Video cassette tapes have record tabs to ensure that recordings are not accidentally erased.

1

To prevent erasure, break off the tab with a screwdriver.

2

To record again, cover the hole with cellophane tape.

VCR maintenance

●Use only tapes with the mark.

●Remove any light adhesive stick-on notes from the video cas- sette tape before putting the tape in the VCR. Removable labels can jam the VCR.

●Periodic maintenance is required to maintain your VCR’s excel- lent performance. This VCR has an Automatic Head Cleaner. However, the video heads will require replacement eventually. Only an authorized service center should perform this service.

1

2 3

1

2

Helpful Hints

•Do not mix alkaline and man- ganese batteries.

•Do not mix old and new batteries.

Image 5

Contents VRA601AT For Customer Use Dear Philips Magnavox product ownerThis bolt of lightning indi- cates uninsulated material Model No Serial NoIntroduction FeaturesSafety Precautions Table of Contents Putting Batteries in the Remote Control Before Using Your VCRVCR maintenance Removing the Plastic Cover from the Front PanelDisconnect the antenna or cable from your TV Hookups Without a Cable Box/Direct Broadcast SystemPlug in the TV and the VCR Hookups Without a Cable Box/Direct Broadcast System cont’dRecording/Viewing Any Channel Hookups With a Cable Box/Direct Broadcast SystemConnections TV’s Antenna Recording One Channel/Watching AnotherVideo Cable Hookups With a Stereo TVPress the Menu button. The display shown below will appear Turning on Your VCR2Turn on the TV Press the Menu button Automatic Channel SetupAdding/Deleting Channels Automatic Channel Setup cont’dPress the STATUS/EXIT button once or twice to exit Reviewing Memorized ChannelsYou make each entry within 60 seconds of the previous entry Follow the steps below to set your VCR’s clock. Make sureDaylight-Savings Time Language Selection Remote Control Buttons Eject Button Remote Control Buttons cont’dPress to eject the tape Clear ButtonStatus Display example only On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status ON, then select Counter only OFFVCR Display Panel Front Panel Rear Panel 1Turn on the TV 2Insert a tape in the VCR PlayingRead and follow the steps below to play a tape RECord light will appear RecordingInsert a tape with its record tab intact in the VCR Recording One Channel/Watching Another One-Touch Recording Daily Timer RecordingDo each step within 60 seconds of the previous step Timer Recording cont’d Tape Speeds Timer Recording cont’dChecking or Cancelling Timer Recordings RF coaxial cable Rerecording Tape DuplicationPress the F.FWD/B button so that on appears beside Repeat PlayPress the PLAY/o button or the STOP/p button to select Real-Time Counter Memory Press the Time Search button Time SearchForward and Reverse Searching SP/LP/SLP Special Effects PlaybackSuper High Speed Searching LP/SLP Viewing a Still PictureAutomatic Operation Features Understanding On-Screen Displays Multi-Channel Television Sound SystemSpecifically… MonitorMulti-Channel Television Sound System cont’d Hi-Fi Stereo Sound System Please see additional notes on Hi-Fi Stereo Sound System cont’dHIFI. on will appear to the right of Hifi on the screen Helpful Hints Helpful Hints cont’d Cable Box/DBS Output Channel 03 or GlossarySpecifications Model # Serial # Limited WarrantyRemote control PowerTimer AutomaticSupplied Accessories