Philips VRA601AT owner manual Hookups Without a Cable Box/Direct Broadcast System

Page 6

6 Hookups Without a Cable Box/Direct Broadcast System

The basic VCR/TV connection – antenna/cable to VCR to TV – is shown below. If you have a Cable Box or a Direct Broadcast System, please see pages eight-nine. If you have a Stereo TV, please see page 10. After you hook up the VCR, go to page 11 to turn on the VCR.

1

Disconnect the antenna or cable from your TV.

Antenna

Indoor/Outdoor

(300 ohm)

75V
ANT	/
CABLE

75V

ANT /

CABLE

OR

ANTENNA IN

Jack

(on back of TV)

Cable

(75 ohm)

2

Connect the antenna or cable to the ANT(enna) IN Jack of your VCR.

Antenna

Indoor/Outdoor

(300 ohm)

OR

Cable

(75 ohm)

Back of VCR

			AUDIO		ANT
			AUDIO		IN
			L		IN
			L
			OUT	IN
			R
		ANT	VIDEO		OUT
			OUT	IN	CH3 CH4
			OUT	IN
AUDIO
AUDIO		IN
	L	IN
	L
OUT	IN
	R
VIDEO		OUT
VIDEO
OUT	IN CH3	CH4

Image 6

Contents VRA601AT This bolt of lightning indi- cates uninsulated material Dear Philips Magnavox product ownerFor Customer Use Model No Serial No Features Safety Precautions Introduction Table of Contents VCR maintenance Before Using Your VCRPutting Batteries in the Remote Control Removing the Plastic Cover from the Front PanelHookups Without a Cable Box/Direct Broadcast System Disconnect the antenna or cable from your TVHookups Without a Cable Box/Direct Broadcast System cont’d Plug in the TV and the VCRHookups With a Cable Box/Direct Broadcast System ConnectionsRecording/Viewing Any Channel Recording One Channel/Watching Another TV’s AntennaHookups With a Stereo TV Video CableTurning on Your VCR 2Turn on the TVPress the Menu button. The display shown below will appear Automatic Channel Setup Press the Menu buttonAutomatic Channel Setup cont’d Adding/Deleting ChannelsReviewing Memorized Channels Press the STATUS/EXIT button once or twice to exitFollow the steps below to set your VCR’s clock. Make sure You make each entry within 60 seconds of the previous entryDaylight-Savings Time Language Selection Remote Control Buttons Press to eject the tape Remote Control Buttons cont’dEject Button Clear ButtonIf you select Status ON, then select Counter only on On-Screen Status DisplaysStatus Display example only If you select Status ON, then select Counter only OFFVCR Display Panel Front Panel Rear Panel Playing Read and follow the steps below to play a tape1Turn on the TV 2Insert a tape in the VCR Recording Insert a tape with its record tab intact in the VCRRECord light will appear Recording One Channel/Watching Another One-Touch Recording Timer Recording Do each step within 60 seconds of the previous stepDaily Timer Recording cont’d Timer Recording cont’d Tape SpeedsChecking or Cancelling Timer Recordings Rerecording Tape Duplication RF coaxial cableRepeat Play Press the PLAY/o button or the STOP/p button to selectPress the F.FWD/B button so that on appears beside Real-Time Counter Memory Time Search Press the Time Search buttonSuper High Speed Searching LP/SLP Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Viewing a Still PictureAutomatic Operation Features Specifically… Multi-Channel Television Sound SystemUnderstanding On-Screen Displays MonitorMulti-Channel Television Sound System cont’d Hi-Fi Stereo Sound System Hi-Fi Stereo Sound System cont’d HIFI. on will appear to the right of Hifi on the screenPlease see additional notes on Helpful Hints Helpful Hints cont’d Glossary Cable Box/DBS Output Channel 03 orSpecifications Limited Warranty Model # Serial #Timer PowerRemote control AutomaticSupplied Accessories