So that you can identify your machine for service questions or in the event of theft, enter the serial number here. The serial number (PROD.NO.) is printed on the type plate fixed at the back of the device.
MODEL NO. | VR620/07 |
PROD. NO. | .................. |
|
|
Important information for customers in Great Britain
This set is fitted with an approved moulded 13 amp plug. To change the fuse in this plug or to attach a different plug, please proceed as follows:
1Take off the fuse cover and remove the old fuse.
2Insert a new fuse. Suitable fuses are those of the type BS 1362 3A, A.S.T.A. standard or BSI standard.
3Close the fuse cover.
If the attached plug does not meet your requirements, you can cut it off and replace it with a suitable plug. Please observe the following conditions:
If your new plug uses a
If your new plug does not contain a
Please destroy the old,
4Connect the blue cable (neutral 'N') to the terminal in the plug which is marked with the letter 'N' or coloured black.
5Connect the brown cable (live, 'L') to the terminal in the plug which is marked with the letter 'L' or coloured red.
6Do not in any circumstances connect either of the two cables to the terminal in the plug which is marked with the letter 'E', the symbol "\" or coloured green or green / yellow.
Before you refit the plug cover, make sure, that the grip at the bottom of the plug is clamped over the plastic cover of the lead, not just over the two wires.
6 | Introduction |
|