Daily treatment (Required time: approximate 15 minutes)
●Step 1 "CLEANSING"
●Step 2 "MOISTURIZE"
●Step 3 "MASK" (milky lotion)
Standard daily treatment. Fine vibration in “Mask” mode and gentle switching of the electrode will enhance the moisturizing effect of lotion.
Weekly treatment (Required time: approximate 15 minutes)
●Step 1 "CLEANSING"
●Step 2 "MOISTURIZE"
●Step 3 "MASK" (use of sheet mask)
Care for the skin thoroughly once or twice a week in “Mask” mode using a commercially available sheet mask.
How to use
Do not use the product around eyes and ears. (Cause of accidents or bad physical condition)
If you feel something is unusual with your skin or body while using the device, stop using it immediately and consult a skin care specialist. (Cause of accident or poor health)
Step 1 "CLEANSING"
This mode removes fine residue remaining in pores which cannot be removed by just washing.
1.Saturate cotton attached to the body with toner after washing your face. Please use your regular toner or
●Saturate the cotton with toner to the extent that toner permeates the back of the cotton.
Some toner (just with mineral spring or water) may be difficult to bring out a good effect.
2.Press the power switch. (Fig. 6)
●The level indicator lamp will be turned on, and "CLEANSING" on the mode indicator lamp will start flashing. If a lamp in another
mode is flashing, press the mode switch button to switch to "CLEANSING.”
3Choose "the strength" of electrical potential with the Level switch button. Switch the "strength" with the level switch button according to the condition of your skin.
●Every time the level indicator button is pressed, the high, medium, and low of the electrical potential will be switched. There will be no change in vibration strength.
●The memory function memorizes the "strength" when the power has been shut off.
It is recommended that when using the device for the first time or if you feel some discomfort, use the device in "Low."
4Hold the device with your hand touching the back plate of the body. (Fig. 7)
●Make sure to hold the body with your hand touching the back plate.
5Apply cotton to the skin and move the device slowly. (Fig. 8)
●The mode indicator lamp will switch and turn on, and the device will start to vibrate.
●The time for use is within approximate 5 minutes.