Hitachi KH-182B Names of parts and their functions Fig, Preparation before use, How to charge

Page 8

Names of parts and their functions (Fig. 1)

Head (titanium material)

Attach cotton and apply it to the skin. The device vibrate while it is being used.

Mode indicator lamp (orange) Turn the power switch "On," and "CLEANSING" will start flashing. Then, it switches and lights up while the device is being used.

Mode switch button

Every time the button is pressed, the mode for use will be switched.

Power switch (" ")

Turn on the power switch, and it will turn "On." Press it again, and it will turn "Off." An automatic shutoff function is equipped, so if the device is not used around 5 minutes, it will automatically turn "Off."

Body

Body socket

Level indicator lamp

LOW (green): MEDIUM (green): HIGH (red) When the power switch is switched to “On,” the lamp indicating “HIGH,” “MEDIUM,” or “LOW” is turned on.

Preparation before use

Level switch button

Every time the button is pressed, "the strength" of the electrical potential will change. There will be no change in vibration strength.

Charge indicator lamp

During charge : The lamp turns on. (Red)

After charging is completed : The lamp turns off.

Buzzer (Switching sound/warning sound/finish sound)

Every time the switch or button is pressed, the switching sound will beep. If the warning sound beeps while the device is being used, this is an indication to recharge your batteries. When each mode is finished, the finish sound will beep.

Back plate (titanium material)

Batteries (built-in) Nickel hydride battery: 2 Power adaptor

Model: KH-182B

 

Power plug

Instrument plug

Cord

Accessories

Rings (two)

 

Rings for attaching cotton.

Stand

How to charge

Since this is not fully initially charged, charge before first using.

Make sure to use only 100-240V and use the included power adaptor.

Do not insert and remove the power plug from an electric outlet with wet hands. (Cause of electric shocks and short-circuits)

Do not use in places splashed with water, such as in a bath, or in damp places. (Cause of failures or short-circuits)

1.Turn off the switch, and connect the power adaptor to the main body and electric outlet.

(Fig. 2) Charge indicator lamp

During charge : The lamp turns on. (Red)

After charging is completed : The lamp turns off.

If the plug for the device's power adaptor is pushed in with force, or unnecessarily tilted, the main body socket may be broken.

2.After the standard charging time (5 hours) has elapsed, pull out the power adaptor from the electric outlet and the main body. (Fig. 3)

The main body and the power adaptor become slightly hot, however, this is not unusual.

-4-

Image 8
Contents Page English 1~14 Page Page Safety precautions EnglishCause of a failure or short circuit Motion. Cause of skin trouble or poor physical condition Preparation before use How to chargeNames of parts and their functions Fig Time to charge Moisturize treatment Required time approximate 10 minutes Examples of useQuick treatment Required time approximate 5 minutes Weekly treatment Required time approximate 15 minutes How to useDaily treatment Required time approximate 15 minutes When using cotton When not using cotton Mask About memory function How to use with ACAbout skin sensing function How to preserve SpecificationsHow to remove the nickel-hydrogen batteries Care for main bodyAbout Skin Sensing Function FAQs Page Page Page Page Page Page Page Page Page Page Page Page