JVC LS-M1, LVT1248-002A manual Assembling the speaker stand, Attach the speaker on the stand

Assembly

Before assembling—

•Prepare a Phillips screwdriver.

•Place a large, thick cloth on the floor where you assemble the speaker stand to protect the floor and the speaker stand.

7Assembling the speaker stand

• Tighten the screws firmly so that no space is left between the legs and plates.

1Fix the top plate.

•Align the projection of the legs to the holes of the top plate correctly, then attach them with three of the supplied screws B (M6 x 16 mm).

Leg B (thin)

Screws B (M6 x 16 mm)

Leg A (thick)

Top plate

* The side without spacer should face outside.

2Fix the bottom plate and leg holders.

•Align the projection of the legs to the holes of the bottom plate correctly, then attach them with three of the supplied screws A (M6 x 30 mm).

Screws A	Spacer
(M6 x 30 mm)

Leg holder

Bottom plate

Leg B (thin)

Leg A (thick)

Spacer

Thick cloth (not supplied)

3Finally tighten screws A and B fully.

•Tighten them firmly and fully so that no space is left between the legs and plates.

Installing Speaker

7Attach the speaker on the stand

1Locate the speaker properly by aligning both screw holes of the speaker and the speaker stand.

•Do not install the speaker stand on an uneven surface or in a place subject to vibration.

•Do not install any overweight equipment (over 10 kg) on the speaker stand.

2Fix the speaker with the supplied screws C (M5 x 28 mm).

•Do not overtighten the screws, but firmly enough to prevent the speakers from being shaky.

Spacer

Screw C (M5 x 28 mm)

Specifications

Mass:	5.3 kg each
Maximum load:	10 kg
Dimensions:	See the diagram.

15

632 585

		30
260	330
			2

Unit: mm

Design and specifications subject to change without notice.

English

3