SETUP
Connect Unit to a PC/AT (optional)
Figure 3 illustrates how to connect the PINpad 1000SE device to an Omni 37xx series terminal. For other terminal or controller connections, refer to the reference manual for that controller.
OMNI 37XX | PINPAD 1000SE |
Connect Unit to a PC/AT (optional)
Figure 3 PINpad 1000SE and Terminal Cable Connections
1Disconnect power from the terminal.
2Connect the modular plug on the cable to the modular jack on the rear of the PINpad 1000SE device.
3Connect the other end of the cable to the PlNpad port on the rear of the terminal.
4Reconnect power to the terminal.
If the PINpad 1000SE device is going to be connected to an IBM PC/AT or compatible for general use, or the PC/AT will be running MKIXOR software for key insertion, VeriFone sells special cable products to provide power to run the PINpad 1000SE (refer to Accessories and Documentation). Figure 4 illustrates how to connect the PINpad 1000SE to an IBM AT or compatible computers.
Figure 4 PINpad 1000SE and IBM AT Cable Connections
12PINPAD 1000SE INSTALLATION GUIDE