Multiquip manual BA-SERIESTROWEL Initial START-UP, Centrifugal Kill Switch

BA-SERIESTROWEL — INITIAL START-UP

3.Place the centrifugal kill switch (Figure 24) in the "ON" position. For models that use this feature.

CAUTION

NEVER disable or disconnect the centrifugal kill switch. It is provided for the operators’ safety and injury may result if it is disabled, disconnected or improperly maintained.

Figure 24. Centrifugal Kill Switch

4. Place the Choke Lever (Figure 25) in the "OPEN " position

Figure 25. Engine Choke Lever

5.Grasp the starter grip (Figure 26) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.

Figure 26. Starter Grip

6.If the engine has started, slowly return the choke lever (Figure 25) to the CLOSED position. If the engine has not started repeat steps 1 through 5.

7.Before the trowel is placed into operation, run the engine for several minutes. Check for fuel leaks, and noises that would associate with a loose guard ring and/or covers.

8.To begin troweling, rotate the throttle (Figure 27) toward the "RUN" position.

Figure 27. Throttle (Run Position)

BA-SERIES WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #6 (07/06/10) — PAGE 25