Multiquip BA Daily 8-10 Hours, Weekly 50-60 Hours, Monthly 200-300 Hours, Yearly 2000-2500 Hours

BA-SERIES TROWEL — MAINTENANCE

NOTE

See the engine manual supplied with your machine for appropriate engine maintenance schedule and troubleshooting guide for problems.

At the front of the book (Page 7) there is a “Daily Pre-Operation Checklist ”. Make copies of this checklist and use it on a daily basis.

CAUTION!

ALWAYS allow the engine to cool before servicing. NEVER attempt any maintenance work on a hot! engine.

MAINTENANCE SCHEDULE

Daily (8-10 Hours)

1.Check the oil level in the engine crankcase and gear box, fill as necessary.

2.CheckV-belt.

Weekly (50-60 Hours)

1.Relube arms, thrust collar and clutch.

2.Replace blades if necessary.

3.Check and clean or replace the engine air filter as necessary.

4.Replace engine oil and filter as necessary, see engine manual.

Monthly (200-300 Hours)

1.Remove, clean, reinstall and relube the arms and thrust collar.Adjust the blade arms.

2.Remove, clean, reinstall clutch.

Yearly (2000-2500 Hours)

1.Check and replace if necessary the arm bushings, thrust collar bushings and shaft seals.

2.Check pitch control cables for wear.

3.Adjust blade speed.

Trowel Arm Adjustment Procedure

NOTE

The following procedure should be followed to adjust trowel arms when it becomes apparent that the trowel is finishing poorly or in need of routine maintenance.

A level, clean area to test the trowel prior to and after is essential. Any unlevel spots in the floor or debris under the trowel blades will give an incorrect perception of adjustment. Ideally, a 5 x 5" three-quarter inch thick flat steel plate should be used for testing.

1.To determine which blades need adjustment, place the trowelinthetestarea(three-quarterinchthickplate)andlook for the following conditions:

■Pitch the blades as flat as possible and look at the adjustment bolts.They should all barely make contact with the lower wear plate on the spider. If you can see that one of them is not making contact, some adjustment will be necessary.

■Is the machine wearing out blades unevenly (i.e. one blade is completely worn out while the others look new)?

Figure 39 below illustrates a "worn spider bushings or bent trowel arms". Check to see that adjustment bolt is barely touching (0.10" max. clearance) lower wear plate. All alignment bolts should be spaced the same distance from the lower wear plate.

Figure 39. Worn Spider Plate

Figure 40 below illustrates the "correct alignment " for a spider plate (as shipped from the factory).

Figure 40. Correct Spider Plate Alignment

PAGE 30 — BA-SERIES WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #6 (07/06/10)