3Com 5112M-TPLS Setting the Dip Switch, 1. Security Module Dip Switch SW1 Location

Setting the Dip Switch

The Security Module has one 4-switch DIP switch (SW1) located on the module. The functions of the DIP switch settings on the Security Module are ignored if a management module is already installed in the concentrator. For this reason, use management commands, rather than the DIP switch, to configure the module.

If a management module is installed in the concentrator, you may skip this section and proceed to the Installing the Module section later in this chapter.

Figure 3-1 shows the location and default settings of the DIP switch.

Figure 3-1. Security Module Dip Switch SW1 Location

Installing and Operating the Module 3 - 5