To install the tie-wrap kit:

1.Remove the hex nut from the bottom of the connector located on the module faceplate.

2.Using the Phillips-head screw provided in the tie-wrap kit, attach the tie-wrap bracket to the module (Figure 3-2).

Figure 3-2. Attaching the Tie-Wrap Bracket to the Module

3. Insert the tie-wrap through the opening on the tie-wrap bracket.

Installing and Operating the Module 3 - 9

Page 45
Image 45
3Com 5112M-TPLS installation and operation guide Attaching the Tie-Wrap Bracket to the Module