INSTALLATION
Remove all packing material and accessories. Examine the oven for any damage such as dents or broken door. Do not install if oven is damaged.
NOTE: This unit is not designed for 50 Hz or any circuit other than a
Countertop Installation
1.Select a level surface that provides enough open space for the intake and/or outlet vents.
_
_
A minimum clearance of 3 inches is
required between the oven and any
adjacent wall. One side must be open.
Built-In Installation
It is necessary for you to purchase an Optional Kit for
Contact the store where you purchased your oven for an optional
Model No. |
| |
JMC8100AD | (27 | inch) JXA1027 |
| (30 | inch) JXA1030 |
When installing in a
situation, the oven requires an
opening for installation. ,,
(27 inch): 25-1/2 (w) x 16-1/16 (h) x 21 "(d)
(30 inch): 28-3/16"(w) x 16-1/16"(h) x 21 "(d)
•Do not remove the legs from the bottom of the oven.
•Blocking the intake and/or outlet openings can damage the oven.
•Plug your oven into a standard
•Leave a minimum clearance of 3 inches above the oven.
•Do not remove the legs from the bottom of the oven.
•Blocking the intake and/or outlet openings can damage the oven.
•Place the oven as far away from radios and televisions as possible.
Operation of microwave oven may cause interference to your radio or television. (See page 7.)
•If the cabinet is covered with a protective film, remove the film.
2. Plug your oven into a standard
Be sure the electrical circuit is at
least 15 amperes and that your microwave oven is the only appliance on the circuit.
WARNING: If installing the microwave oven over an electric
oven, it must only be installed over the following Electric Ovens:
(27 inch) JJW8527, JJW9527 series
(30 inch) JJW8530, JJW9530 series If installed over any other than the
listed Electric ovens, the microwave
could be damaged and the warranty would be void.
microwave oven is the only appliance on the circuit.
10