The
The next section describes the features you can set for the Security Module.
Configuring the Module
The ONline management modules (EMM, TRMM, and FMM) provide management capabilities for the ONline System Concentrator and its modules. If a management module is already installed, the DIP switch settings on the Security Module are ignored. For this reason, 3Com recommends that you use management commands, rather than the DIP switches, to configure the module and the ports.
When you first install the module and network management is present:
1.The network defaults to isolated mode and the ports are automatically disabled so that unapproved users cannot be added.
2.You must enable the ports you wish to use and set the module to the appropriate network through the management commands.
The following sections describe the management commands to set the above features. Refer to the appropriate ONline management module installation and operation guide and the ONline Management Commands Guide for additional information on available network management features.
Installing and Operating the Module 3 - 13
