48 Setting up your TV
To program channels automatically:
1Configure the antenna input source, if you have not already done so, see “ANT/CABLE IN” on page 46.
2Press the MENU button and open the Installation menu.
3Highlight Channel Tuning, and then press the ENTER button.
(Sample Image) Setup menu - Installation selection
4Highlight Auto Tuning, and then press the ENTER button to open the Channel Program menu to begin channel programming.
! Cable Scanning channels, please wait...
6%
Number of Channels Found - 7
Scanning Analog Channels
Channel - 9
Cancel
(Sample Image) Installation menu - Channel selection
The TV will automatically cycle through all the antenna/cable channels, and store all active channels in the channel memory. While the TV is cycling through the channels, the message “Scanning channels, please wait” appears.
5To cancel channel programming, press the EXIT button on the remote control or highlight Cancel in the
When channel programming is complete, press the CH ▲/▼(arrow) buttons to view the programmed channels.