Remote control

The Sonata AR30 and DR30 are both supplied with a Navigator remote control that operates the units.

Standby/On

Switches the unit between Standby and On mode.

0-9 numeric buttons

Press to recall stored presets.

Numerical select

To recall a preset number greater than ten, press -/-- followed by the required preset number.

Mute

Mutes the audio on the unit. Press again to cancel mute.

Band

AR30 – Switches the unit between FM, AM and SIRIUS (if fitted, US version only) bands.

DR30 – Switches the unit between DAB and FM bands.

Volume

Increases or decreases the volume of the unit.

It is also used to change the value of the selected menu settings in audio setup and advanced setup menus.

Navigation

In preset mode, press to step through the preset stations.

To navigate around presets, press the directional arrows up or down. If an iPod is inserted in the attached docking station and MP3 source selected, you can use the navigation keys to browse your iPod’s content.

Select

Press to accept the item/function highlighted in the display menu, or while navigating your iPod.

In tuner mode, press and hold to store the current station in the preset bank.

Note: If browsing through DAB stations, press Select to immediately tune to the current station (DR30 only).

Skip/Scan

Sonata AR30

–In manual mode, press and hold to scan to the next or previous station. Short press once to fine-tune frequency. Refer to the 'Tuning and listening' section of this manual.

Sonata DR30

–In FM manual mode, press and hold to scan to previous or next available stations. Short press once to fine-tune frequency. Refer to the 'Tuning and listening' section of this manual.

–In DAB manual mode, you can step through the stations stored

alphabetically in the DAB database. Press the button to step through to previous stations or to step through to the next stations. If you wish to perform a complete scan of all available stations, press and hold

down the	button. Refer to the 'Tuning and listening' section of this
manual.

Note: When MP3 input is selected, and an iPod (depending on the model and generation) is inserted into the attached DD30 dock, the

buttons will skip through the track lists. Press and hold the buttons, will scan through the current track.