English
Dansk | Deutsch | Español | Français | Italiano | Nederlands | Svenska |
INTRODUCTION
What distinguishes the two units
The connection panel on each unit identifies it by name: TRANSMITTER or RECEIVER. Two Bose® link jacks and a Channel button further distinguish the transmitter.
For compatibility, the two units have a matching Setup Code, set at the factory with both switches in the “down” position (Figure 2). A Status LED lights when each unit is plugged in and the two units are communicating.
Figure 2
Connection | Transmitter | Receiver |
panels on the two |
|
|
units |
|
|
Bose® link jacks | Channel switch | Bose link jack |
Status LED 
Note: For information on the meaning of the different Status LED lights, refer to “Check the indicators and settings” on page 9.
Choosing a place for each unit
Place the transmitter in the same room with the LIFESTYLE® system media center. Place the receiver in the same room with your Bose® link expansion product.
Note: Use of the audio link with products that are not Bose
Considerations for positioning:
•Place each unit upright with all feet flat on a level surface, such as a floor, table, or shelf.
•Do not tip either unit on its side.
•Place each unit within 2 meters (7 feet) of the product to which it is connected (using the supplied Bose link A cable).
•Keep the two units within 23 meters (75 feet) of each other.
•Be aware that the strongest signal direction is above and around, not below, the transmitter.
5