Check the indicators and settings, Status LED

English

Dansk

Deutsch

Español

Français

Italiano

Nederlands

Svenska

SETUP

To control volume when a non-Bose product is the sound source:

•There is no need for an expansion room remote control.

•Use the remote that came with the tuner/receiver in the room where it is connected to the transmitter.

•Use the volume control on the system, radio, or powered speakers connected to the receiver in the other room.

To control non-Bose or older Bose® products in the expansion room:

•Use a Bose® link remote control or the PERSONAL® music center II to select audio from the LIFESTYLE® system in the main room.

•Use the product remote or console control for local volume adjustments.

Check the indicators and settings

Before you use the audio link, you may want to check some of the indicators and settings that make your expansion products work together smoothly.

The Status LED

On the connection panel of both the transmitter and the receiver, the Status LED indicates how the two units are communicating, as shown in the table below.

Status LED	Blinking green	Solid green	Blinking orange	Solid orange
On the	Searching for	Receiver	Not	Powered on,
transmitter	receiver	located	applicable	no communication
On the	Searching for	Solid signal	Weak signal	Weak or no signal
receiver	transmitter	received	received	received

On the receiver, a blinking or solid orange light indicates a communications problem. Reposi- tioning the transmitter, receiver, or both, may resolve the problem and cause both LEDs to change to solid green. For further information, refer to “Troubleshooting” on page 11.

The transmitter Channel button

You can use the Channel button to narrow the selection of frequencies the transmitter uses.

The transmitter is factory-set to avoid WiFi Channel 11. This helps prevent performance problems, such as slow or intermittent data transmissions, on a wireless network. If you have a wireless network set up on another channel, you can set up your transmitter to avoid that channel, or you can move the WiFi network to Channel 11.