Position the assembly face down, as shown

Assembly

#8 x 2.9 cm Screw

Side Rail

5	Front Tube

•Insert a #8 x 2.9 cm screw through the outside of each side rail and into the ends of the front tube.

IMPORTANT! Please follow the next assembly (step 6) carefully to completely secure the front tube to the side rails.

Retainer with Lock Nut

6	Rounded Side
	M4 Lock Nut (Inside Retainer) - 2

•Fit a retainer with lock nut onto the end of the screw and to the inside of a side rail.

Hint: A lock nut has been factory assembled to the retainer. During shipment, the lock nut may have fallen out of the retainer. If it has, please fit it into the hexagonal hole in the retainer so that the rounded side of the lock nut faces out.

•Tighten the screw with a Phillips screwdriver. Do not over-tighten.

•Repeat this procedure to fasten the screw in the other end of the front tube and side rail, using the remaining retainer with lock nut.

Press Tab

Kickstand

7	Receptacles

•Position the assembly face down, as shown.

•While pressing the tab on each end of the kickstand, insert the kickstand into the receptacle in each side rail, as shown.

•Push the kickstand into the receptacles until the tabs "snap" into place. Make sure you hear a "snap" on each side.

•Pull the kickstand to be sure it is secure in the receptacles.