Assembly
IMPORTANT! Before assembly or each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing, damaged or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts.
Cross Brace (Push)
Button
Side Rails
1
•Position each side rail so that the button faces outward.
•Fit the cross brace between the side rails, as shown.
•Push the cross brace down to "snap" it into place. This may require a lot of force.
#8 x 1.9 cm Screw
Cross Brace
Side Rails
2
• Insert a #8 x 1.9 cm screw through the hole in the bottom of |
each side rail and into the cross brace. Tighten the screws with |
Seat Back Tube
Press Tabs
Side Rail Sockets
3
•Insert the seat back tube into the socket in each side rail.
•While pressing the tabs on the ends of the seat back tube, continue to insert the seat back tube into the sockets in each side rail, until the tabs "snap" into place. Make sure you hear a "snap" on each side.
•Pull the seat back tube up to be sure it is secure in the side rail sockets.
Side Rail Hole
Front Tube
a Phillips screwdriver. Do not |
4
Side Rail Hole
Vibrations Unit
•Locate the hole in each side rail.
•With the vibrations unit facing forward, fit the front tube to the side rails, as shown. Hold the front tube in place and proceed to step 5.
3