Fireplace
Installation
Continued
Removing Glass Door
If replacement of glass is necessary, the entire assembly, glass and frame, must be replaced. If glass is broken, wear gloves and tape the remaining fragments onto the frame.
1.Remove screen assembly by pushing the rod either left or right and then down and forward to remove screen/rod assembly from the fire- box. Set assembly aside.
2.Lift up on latches to unlock. There are two on top of firebox and two below firebox that hold glass door in place (see Figure 42).
3.While holding glass door to prevent it from falling and causing injury, remove the five screws from the hinge located on the left side of door frame assembly (see Figure 42).
4.Remount the new frame at the hinge with five new screws before closing door. This will ensure seating of the gasket.
5.Close glass door frame. Lock latches by plac- ing the bar under the tab on door and pushing down and back on latch (see Figure 42).
6.Replace screen/rod assembly by reversing step 1.
7.Replace louvers by reversing procedure under
Removing Louver Panels, page 23.
Unlock 
Lock
Latch
Screw
Hinge
Glass Frame
Assembly
Figure 42 - Removing/Replacing Glass
Door
Cleaning Glass Door
See Cleaning and Maintenance on page 31.
Installing Optional Brick liner Model BL32D
WARNING: If fireplace has been running, turn off and un- plug fireplace. Let cool before installing brick liner.
This brick liner kit is optional. You may purchase brick liner from your local retailer or see page 37.
CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Excessive force will break brick panels.
1.Remove top and bottom louvers to allow access to door latches.
2.Unlock door latches and open glass door. See steps 1 and 2 of Removing/Replacing Glass Door, page 23.
3.If installing brick liner in new fireplace, go to step 4. If installing brick liner in an existing fireplace, carefully remove logs, lava rock and ember material.
4.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.
5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 43).
6.Install left side brick panel by sliding it be- tween the grate and the side of the firebox (see Figure 43).
7.Install the right brick panel using the same method described
8.Replace deflector shield using screws removed in step 4.
Rear Brick
Panel
Figure 43 - Installing Rear Brick Panel
24 | www.desatech.com |
