Fireplace
Installation
Continued
Installing Optional Wireless
NOTICE: Use only alkaline bat- teries (not included).
Installing Remote Receiver
1. Open bottom louver and locate the switch bracket on the left.
2. Unscrew the switch bracket. Lean bracket forward so you are able to access the back of the remote receiver.
3. Locate the battery clip mounted on the back of the receiver. Slide a
4. Attach the terminal wires to the battery.
5. Connect wires from receiver to TH and TPTH to control valve (see Figure 39).
6. Replace the switch bracket.
Receiver
Terminal
Wires
Battery Clip
Figure 38 - Attaching Alkaline Battery to
Receiver
To Optional
Remote
Accessory
Figure 39 - Control Valve Terminals
Installing
Held Remote Control Unit
1. Remove battery cover on back of remote control unit (see Figure 40).
2. Attach terminal wires to the battery. Place battery into the battery housing.
3. Replace battery cover onto remote control unit.
| Remote Control Unit |
| Battery Cover |
Terminal |
|
Wires |
|
Battery | |
Battery | Housing |
Figure 40 - Installing Battery in Hand-
Held Remote Control Unit
Removing/Replacing Glass Door
CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For replacementpartinformationsee Replacement Parts, page 36.
CAUTION: Wear gloves and safety glasses while handling or removingbrokenglass.Donotre- moveifglassishot.Keepchildren and pets away from glass.
WARNING: If fireplace has been running, turn off and un- plug fireplace. Let cool before re- moving glass door or louvers.
Removing Louver Panels
Remove the top and bottom louver panels by si- multaneously pulling both top end spring latches towards the center of the appliance until they are disengaged from the locating holes (see Figure 41). Repeat for bottom spring latches and pull the lou- vers outward. To install or replace items removed, simply reverse the procedures above.
Spring Latch
Louver Panel
Figure 41 - Removing Louver Panel
www.desatech.com | 23 |
