Desa T32p-a SERIES, CGDV32pR Venting Installation, Square Termination, Vertical V Horizontal H

Venting Installation
instructions
Continued
	Siding
	Standoff
Minimum Pipe	Screws
Overlap 11/4"
Wall
Firestop
Direct
Vent	High Wind
Pipe
	Termination
Maintain 1"	Apply
Minimum Air Space
	Mastic to
Around Outer Pipe
	Outside
When Penetrating
	Edge of
a Wall
	Standoff
10 3/4" x 10 3/4"
Framed Opening	Exterior Wall
	with Vinyl
	Siding

Figure 13 - Typical Horizontal Termination Cap Mounting with Additional Siding Standoff Installed

Horizontal Termination Configurations Figures 14 through 18 show different configura- tions and alternatives for venting with horizontal termination. Each figure includes a chart with critical minimum and maximum dimensions which MUST be met. IMPORTANT: If using a venting configuration of only horizontal venting with no vertical run, a 1/4" rise for every 12" of run toward the termination is required.

NOTICE: Do not seal termination cap to vent pipe. Cap must be removable for vent inspection and maintenance.

WARNING: Never run vent downward as this may cause excessive temperatures which could cause a fire. Operation of improperly installed and main- tained venting system could result in serious injury, property damage or loss of life.

GROUND FLOOR INSTALLATION

Recommended Applications:

•Installation using cabinet surrounds

•Through the wall using round or square termi- nation (up to 12") horizontal pipe)

•NOT FOR CORNER INSTALLATION

45° Elbow

Horizontal High

Wind Square

Termination

	Adjustable
	Pipe 12"
Wall	Max.
Firestop
	Square Termination
	Vertical (V) Horizontal (H)
	29 3/4"	17" max.
45° Elbow		Exterior
Wall		Portion of Wall
		Firestop (Round
Firestop
		Termination Only)

Slide Ring Over Elbow to Complete Connection

Horizontal Round

Termination

Round Termination

(Kit HTK Shown)

Figure 14 - Horizontal Termination

Configuration for Square or Round

Termination

116646-01D www.desatech.com 11