Installation (Cont)
Internal Battery Activation and/or Replacement
A type CR2032 battery is installed in a compartment behind the front panel of the homebase. If the unit is being used for the first time, the battery must be activated. A plastic insulator prevents contact with the battery terminals. This insulator must be removed for the calendar/ clock backup functions to operate. To remove the insulator, simply pull out the plastic tab extending from the right side of the unit below the marker pen.
To remove and replace the battery, proceed as follows:
Marker pen storage
Pull out this tab
(“REMOVE THIS TAB”) completely to enable battery operation
1.Lay the homebase on a flat surface with the front panel facing up.
2.Grasp the center of the front panel at the top and bottom edge and bow the panel out until it clears the left side by the control buttons. Remove the panel to reveal the battery compartment cover.
3.With your thumb, press the cover in the direction indicated by the arrow until it disengages. Lift off the cover.
4.Carefully remove the battery.
5.Insert the battery in the compartment paying special attention to battery orientation (+ side facing up).
6.Replace the battery compartment cover by first engaging the
7.Replace the front panel by engaging the right side under the protruding lip; then slightly bow the panel out and slide the left side under the lip by the control buttons.
8.The battery backup feature should now be operational.
Control Buttons |
| Protruding Lip | |
|
| ||
|
| (Left Side) | |
|
| Protruding Lip | |
|
| (Right Side) | |
|
| Battery Compartment | |
homebase Front Panel | Battery Compartment | ||
Cover | (CR2032) | ||
| |||
DPF710K |
| 11 |