Homebase Refrigerator Installation

Installation

	homebase Bracket Mounting Holes	Refrigerator Door Front Surface
Wire Post(s)	DC Input		Refrigerator
Wire Post(s)	Connector		Door Seal
	Connector		Door Seal
Power Adapter	Power Adapter		DC Power Wire
Power Adapter	Power Adapter		1 inch
Wire Notch	Wire Notches		1 inch
Wire Notch	Wire Notches
Adhesive		homebase	Wire Cover
Foam Pads
			Wire Cover
			See Step 9
	Wall Mount Bracket		Caution
	Wall Mount Bracket		Below
			Below

1.Remove the protective backing from one side only of the two adhesive pads and position them on the back of the wall mount bracket as shown.

2.Clean the homebase mounting area on the refrigerator with isopropyl alcohol; do not use a glass cleaner.

3.Place the wall mount bracket in the desired area and level the top of the bracket.

Note: Before removing the remaining protective backing from the two adhesive pads, be sure of the homebase mounting location as the adhesive pads are not designed to be removed and repositioned once they are applied to the refrigerator surface.

4.Remove the protective backing from the two adhesive pads, line up the top of the bracket, and firmly press and hold the bracket in place on the refrigerator surface to ensure the pads adhere securely.

Note: 3M™ recommends waiting 24 hours for maximum adhesion prior to mounting your homebase to the mounting bracket.

5.Connect the power adapter plug to the DC input connector at the rear of the homebase.

6.Choose the direction of the adapter wire in reference to the AC wall outlet. Place the DC wire in the corresponding wire notch.

7.Check the amount of wire required to reach the AC outlet. Spool excess wire on the four posts inside the rear cavity of the homebase.

8.Attach the homebase to the bracket by lining up the homebase bracket mounting holes with the wall bracket mounting tabs, and slide the homebase down until the mounting tabs engage the mounting hole slots.

9.Cover the power adapter wire with the clear, black or white wire cover; seal the cover using the double-sided tape and dress the wire, adhering it to the refrigerator surface.

Caution: The power adapter wire routing follows the right angle contour of the refrigerator door. Do NOT cover the DC power adapter wire using the double-sided tape after the 90 degree transition from the front refrigerator surface to the side surface and for at least one inch rearward of the refrigerator seal. This will allow movement of the power adapter wire as the refrigerator door opens and closes.

DPF710K