Installation (Cont)
Plastic Wall Anchor (2) | Drill 1/4” Hole | |
if Needed | ||
(2 Places) | ||
|
Angle Mount Bracket
Mounting Tabs
Wall Surface
Angle Mount | Mounting Hole | |
Screw (2) | Bracket (2) | Template |
homebase Wall Mount Installation Using the Angle Mount Brackets
Note: Foam adhesive pads are not recommended when mounting the angle mount brackets to a wall surface.
Mount the brackets to the wall surface as follows:
1.Position the mounting hole template at the desired place on the wall; level the template and mark the position of the two lower holes.
2.Drill two holes using a 1/4” (6mm) drill bit. If a wall stud is not present, insert the plastic anchors into the holes until flush with the wall surface .
Caution: Do not over tighten the screws; otherwise, the angle mount bracket could be damaged.
3.Align each angle mount bracket with the respective hole and/or wall anchors; insert a flathead screw through each bracket and secure the bracket to the wall.
4.Connect the power adapter plug to the DC input connector at the rear of the homebase.
5.Choose the direction of the adapter wire in reference to the AC wall outlet. Place the DC wire in the correspond- ing wire notch.
6.Check the amount of wire required to reach the AC outlet. Spool excess wire on the four posts inside the rear cavity of the homebase.
7.Attach the homebase to each bracket by lining up the homebase bracket mounting hole with the associated bracket mounting tabs, and slide the homebase down until each mounting tab engages the mounting hole slot.
8.Cover the power adapter wire with the clear, black or white wire cover; seal the cover using the
10 | DPF710K |