Assembly
Track |
Track |
Base |
1 |
•Insert a track into one side of the base as shown.
•Insert the other track into the opposite side of the base.
| #8 x 1/2" Screw |
2 | Bottom View |
•Turn the assembly over so the bottom of the base is facing you.
•Insert four #8 x 1/2" screws through the base and into the tracks. Tighten the screws.
•Turn the base upright.
Base |
Base Door |
3 |
•Position the base door so that the decorated side is facing you.
•Insert the peg on one end of the base door into the hole in the base.
•Bend the door slightly and insert the other peg into the hole in the base.
4 | Base Support |
|
• Insert and “snap” the base support into the base.
| #8 x 1/2" Screw |
| Ramp Cover |
5 | Ramp |
|
•Fit a ramp cover onto a ramp as shown.
•Insert two #8 x 1/2" screws into the top of the cover and tighten them.
6 | #8 x 1/2" Screw |
|
•Turn the ramp over and insert four #8 x 1/2" screws into the back of the ramp. Tighten the screws with a screwdriver.
•Repeat this procedure to attach the other ramp cover.
4