Assembly
IMPORTANT! Before each use or assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact
Never substitute parts.
Button Hole
Mesh Cover
Plastic Mesh Cover Stay
| Frame |
Middle Hole | Middle Hole |
3
Frame Tubes
1
Base 
•Open the base and position it upright on a flat surface, as shown.
•Locate the end of the base with the mesh cover. Insert the entire plastic mesh cover stay into one of the button holes in the mesh cover.
•Be sure to tuck the plastic mesh cover stay away from the button hole in the mesh cover.
Canopy Tunnel
Metal
Canopy
Stay
2
• Insert the metal canopy stay through the canopy tunnel.
•Position the ends of the frame tubes against the middle holes in a frame.
| Rounded |
| Side |
M6 x 15/8" Screw - 4 | M6 Lock Nut - 4 |
| |
M6 Lock Nut Frame |
|
Frame Tube
Frame Tube
4
Push Base Up
•Insert an M6 x 15/8" screw through each frame tube and into the frame.
•Fit an M6 lock nut (with the rounded side toward the fabric) into each middle, hexagonal opening on the back of the frame.
Hint: You may find it easier to access the hexagonal opening
4 on the back of the frame if you push the base up, so that the fabric is out of the way.