Use
To Unfold
PUSH | PUSH |
Frame
| 3 | Groove | |
1 | Base Wire | ||
|
Sides of Base Wire
•Position the product upright on a flat surface.
•Grasp both sides of a base wire.
•Pull both sides of the base wire outward and then let the base wire rotate down.
Note: If the base wire does not freely rotate down, pull the sides of the base wire further outward.
•Push down on the product to be sure each side of the base wire is
in the correct position. The base |
|
wire should rest in the groove in |
|
each frame. | CORRECT |
• Repeat Use steps 1- 3 to unfold the other base wire.
Using the Canopy
| Frame |
Groove | Groove |
2
Sides of Base Wire
•Lift the product up slightly so that each side of the base wire “snaps” into the groove in each frame. Make sure you hear a “snap”.
Canopy Up 
Canopy
Down
4
• Adjust the canopy up or down.
7