Assembly
Rounded
Side 
M5 x 113/16" Screw
M5 Lock Nut
Metal Canopy Stay
Cover
Upper
Hole
8 
SlotTab
•Position one end of the metal canopy stay against the upper hole in a frame.
•Insert an M5 x 113/16" screw through the hole in the cover.
•Fit the end of the screw through the hole in the metal canopy stay and into the upper hole in the frame.
•Push on the cover to insert and “snap” the tab on the cover into the slot in the frame. Make sure you hear a “snap”.
•Fit an M5 lock nut (with the rounded side toward the fabric) into the upper hexagonal opening on the back of the frame.
•Tighten the screw with a Phillips screwdriver. Do not
•Repeat this procedure to attach the other end of the metal canopy stay and the remaining cover to the frame on the other side of the base.
Toys 
Canopy
Fasteners
Pad
Fastener 
9
•Fasten the pad fasteners to the base fasteners.
•Lift the canopy.
•Attach the toys to the canopy fasteners.
IMPORTANT! Assembly is now complete, but Bounce ‘n Play Activity Dome is not ready for use. Please refer to the Use instructions, on this page, beginning with step 2.
6