Using Restraint Features
Using Restraint Features
Recline Bar
THE RECLINE BAR MUST BE INSTALLED BEFORE USING THIS RESTRAINT UNLESS THE TETHER IS USED.
Insert recline bar into the holes in lower rear of restraint prior to installation in vehicle (Fig. A).
IMPORTANT: The bottom of the restraint should be flat on the vehicle seat when installed.
A
Using the Buckle
Fastening the Buckle
1Hold the buckle with one hand.
2Use your other hand to insert one tongue at a time into the buckle. Proper connection is confirmed with a positive click, after inserting the second buckle tongue (Fig. C).
Releasing the Buckle
1Brace the rear of the buckle with hand.
Buckle
Unbuckle
C
Using the Chest Clip
Open the chest clip by squeezing the middle tab, then pull the two pieces apart (Fig. B).
IMPORTANT: The correct height for the chest clip is at the middle of the chest, level with the armpit.
B
2 Use thumb to press release button until tongues are ejected from buckle (Fig. C).
NOTE: Periodically clean the buckle to ensure proper operation. See page 29.
20 | 21 |