Installation
A
B
C
Lap-Shoulder Belt Installation
Long Route
Figure A illustrates a typical long route lap- shoulder belt installation.
WARNING:
•Do not install this restraint using a non- locking ELR vehicle belt, unless a locking clip is used. Refer to the vehicle owner's manual for instructions on correct use of vehicle belts with child restraints.
1 Insert recline bar into holes on rear of restraint (see page 20).
2 Place the child restraint in a forward facing position on the vehicle seat.
3 Pull the vehicle belt out and pass it through the first belt slot, from the front of the restraint to the rear (Fig B).
4 Route the vehicle belt around the back of the restraint then through the second belt slot, from the rear of the restraint to the front (Fig. C).
5 Verify that the vehicle belt is not twisted, then buckle (Fig. D).
6While kneeling on the restraint to push it firmly into the vehicle backrest, remove all slack from the vehicle belt.
•First remove slack from the lap portion of the vehicle belt, then the shoulder portion (Fig. E & F).
7Verify that the vehicle belt is tight and the child restraint is secure.
Refer to Figure G for correct routing of the
IMPORTANT: Always use the Versa- Tether for children weighing more than 50 pounds (22.6 kg). See pages
Removal
Reverse installation procedure.
Upper Anchorage Points
G
Installation
D
E
F
12 | 13 |