Husky Baby Carrier manual Installation

Installation

A

B

C

Lap-Shoulder Belt Installation

Short Route

Figure A illustrates a typical short route lap-shoulder belt installation.

WARNING:

•Always use the Versa-Tether®when installing restraint using the short vehicle belt route (see pages 18–19).

•Do not install this restraint using a non-locking ELR vehicle belt, unless a locking clip is used. Refer to the vehicle owner's manual for instructions on correct use of vehicle belts with child restraints.

1 Place the child restraint in a forward facing position on the vehicle seat.

2 Pull the vehicle belt out and pass it through the first belt slot, from the rear of the restraint to the front (Fig B).

3 Route the vehicle belt under the cover then through the second belt slot, from the front of the restraint to the rear (Fig. C).

4 Verify that the vehicle belt is not twisted, then buckle (Fig. D).

5 While kneeling on the restraint to push it firmly into the vehicle backrest, remove all slack from the vehicle belt.

•First remove slack from the lap portion of the vehicle belt, then the shoulder portion (Fig. E).

6 Verify that the vehicle belt is tight and the child restraint is secure.

•Refer to Figure F for correct routing

Removal

Reverse installation procedure.

Installation

D

E

F

14 15