ENENGLISH
STEERING AID (Pro20)
As opposed to normal servo steering (e.g. in a car), the steering aid has a limited capacity. This means that it has some characteristics that might be considered negative:
-at a low engine rpm or in situations where extra steering force is needed, steering can be considered to be “jumpy”.
-the machine should always be moving when the steering is used. Avoid turning the steering wheel when the machine is standing completely still and the accessory is in the lowered working position.
The steering is adapted in order to produce better results at a normal working speed. This produces major benefits.
Even when the engine is not running, the steering works. However, it is harder to turn in this case, if the machine is to be manoeuvred manually.
DRIVING TIPS
Make sure that there is the correct quantity of oil in the engine when driving on slopes (oil level on “FULL”).
Be careful when driving on slopes. No sudden starting or stopping when moving up or down a slope. Never drive across a slope. Move from the top down, and from the bottom to the top.
The machine, equipped with original accessories, may not be driven on slopes greater than 10º in any direction.
Reduce the speed on slopes and when making sharp turns to prevent the machine from tipping over or you losing control of the machine.
Do not turn the steering wheel to full lock when driving in top gear and at full throttle. The machine can easily topple over.
Keep hands and fingers well away from articulated steering joint and seat bracket. Risk of crushing injuries. Never operate the machine without the engine casing.
SERVICE AND MAINTENANCE
SERVICE PROGRAM
In order to keep the machine in good condition, as regards reliability and operational safety as well as from an environmental perspective, STIGA’s service program should be followed.
The contents of this program can be found in the attached service log.
We recommend that an authorised workshop carries out every service. This guarantees that the work is performed by trained personnel and with genuine spare parts.
At every service, the service log should be stamped. A “fully stamped” service log is a valuable document that improves the machine’s
PREPARATIONS
Unless otherwise stated, all service and maintenance must be carried out on a stationary machine when the engine is not running.
Prevent the machine from rolling by always applying the parking brake.
Prevent unintentional starting of the engine by always stopping the engine, disconnecting the spark plug cable from the spark plug and earthing it. Disconnect the negative cable from the battery.
CLEANING
To reduce the risk of fire, keep the engine, silencer/catalytic converter, battery and fuel tank free from grass, leaves and oil.
To reduce the risk of fire, regularly check the machine for oil and/or fuel leakage.
When washing the machine with water under high pressure, do not point the jet directly at the transmission.
Do not point jets of water directly at the engine. Use a brush or compressed air in order to clean it.
ENGINE OIL
(President - Comfort - Pro16 - Pro20
- Excellent)
Change the oil for the first time after 5 hours running, and then after every 50 hours running or once a season. Change oil when the engine is warm.
Always use a good grade of synthetic oil (service grade SF, SG or SH).
56