Stiga 8211-0276-08 Engine OIL Royal, OIL Filter Engine Pro16 Pro20 Excellent, AIR Filter Engine

Page 12

ENGLISH

Change the oil more often (after 25 hours of operation or at least once a season) if the engine has to operate under demanding conditions or if the ambient temperature is high.

The engine oil may be very hot if it is drained off directly after the engine is shut off. So allow the engine to cool a few minutes before draining the oil.

1. Oil drain pipe (metal):

Unscrew the oil drain plug at the end of the pipe.

Collect the oil in a collection vessel. Then take the oil to a recycling station. Do not allow oil to get on the V-belts.

2.Screw in the oil drain plug. Make sure that the fibre gasket and the O-ring inside the plug are not damaged and that they are in the correct place.

3.Remove the dipstick and fill up with new oil. Oil capacity:

Comfort, President - 1.4 l

Pro16, Pro20 - Excellent - 1.7 l (incl. oil filter) Oil type, summer (> 4ºC): SAE-30

(SAE 10W-30 can also be used. However, oil consumption may increase somewhat if 10W-30 is used. Therefore, check the oil level more regularly if you use this type of oil).

Oil type, winter (< 4ºC): SAE 5W-30

(if this oil is not available, use SAE 10W-30).

Use oil without any additives.

Do not fill with too much oil. This can cause the engine to overheat.

After filling up the oil, start the engine and idle for 30 seconds. Stop the engine. Wait for 30 seconds and then check the oil level.

Check to see if there is any oil leakage. If necessary, fill up the oil up to the “FULL“ mark.

ENGINE OIL (Royal)

Change the oil for the first time after 20 hours of operation (or during the first month), and then after every 100 hours of operation or once every 6 months.

Change oil when the engine is warm. Always use a good grade of synthetic oil (service grade SF, SG or SH).

The engine oil may be very hot if it is drained off directly after the engine is shut off. So allow the engine to cool a few minutes before draining the oil.

Unscrew the oil drain plug at the end of the pipe (fig. 13).

Collect the oil in a collection vessel. Then take the oil to a recycling station. Do not allow oil to get on the V-belts.

Screw in the oil drain plug. Make sure that the fibre gasket and the O-ring inside the plug are not damaged and that they are in the correct place.

Remove the dipstick and fill up with new oil up to the “UPPER” mark.

Oil capacity:

Royal - 0.9 l (= oil quantity at change. In total the engine holds 1.15 l).

Oil type for all seasons: SAE 10W-40.

For extremely low temperatures (< -20° C), use SAE 5W-30.

Use oil without any additives.

Do not fill with too much oil. This can cause the engine to overheat.

OIL FILTER – ENGINE (Pro16 - Pro20 - Excellent)

Replace the oil filter after every 100 hours of operation or once a season.

Before screwing the new filter, oil the filter gasket with engine oil.

Screw the filter by hand, until the filter gasket touches the filter attachment. Then tighten ½ to ¾ of a full turn (fig. 14).

Start the engine and idle to see if any leakage occurs. Stop the engine. Check the oil level. If necessary, fill up the oil up to the “FULL” mark.

AIR FILTER - ENGINE

Comfort - President - Pro16 - Pro20 - Excellent: Clean the foam pre-filter every 3 months or after every 25 hours of operation, whichever comes first.

Clean the paper filter insert once a year or after every 100 hours of operation, whichever comes first.

Royal:

Clean the air filter every 3 months or after every 50 hours of operation, whichever comes first.

Clean the paper filter insert once a year or after every 200 hours of operation, whichever comes first.

All models:

Note! Both filters should be cleaned more often if the machine operates on dusty ground.

1.Remove the protective cover of the air filter (fig.

15- 17).

2.Dismantle the paper filter insert and the foam pre-filter. Make sure that no dirt gets into the carburettor. Clean the air filter housing.

3a. Pro 16, Pro 20:

Wash the pre-filter in liquid detergent and water. Squeeze dry. Pour a little oil on the filter and squeeze in the oil.

3b. President, Comfort:

Replace the pre-filter once a year or after every 25 hours of operation, whichever comes first.

4.Clean the paper filter insert as follows: Knock it lightly against a flat surface. If the filter is very dirty, change it.

57

Image 12
Contents Stiga Park Park President Comfort Royal Pro Briggs & Stratton Honda Royal Pro 16 Pro President Comfort 75 mm Symbols Service BrakeGeneral Controls InstrumentsAdjustable Steering Wheel Power TAKE-OFFDrive Pedal THROTTLE/CHOKE ControlAreas of USE Hour CounterDisengaging Lever Fuel GAUGE/FUEL CAPStarting and Operation Engine CasingChecking the Engine OIL Level Filling the Fuel TankSafety System StoppingStarting Engine Catalytic Converter Pro20 CatService and Maintenance Engine OIL Royal OIL Filter Engine Pro16 Pro20 ExcellentAIR Filter Engine Battery AIR Filter CatalyticSpark Plug Cooling AIR Intake EnginePatent Design Registration Steering Cables President Comfort RoyalSteering Chains Pro16 Pro20 W. s t i g a . c o m

8211-0276-08 specifications

The Stiga 8211-0276-08 is a versatile and efficient lawn mower designed for residential use, providing homeowners with an exceptional mowing experience. Known for its robust construction and innovative features, this model ensures a neatly manicured lawn with minimal effort.

One of the standout features of the Stiga 8211-0276-08 is its powerful engine. The mower is equipped with a reliable four-stroke engine that delivers efficient performance and ensures that grass cutting is smooth and consistent. This engine not only boosts cutting power but also enhances fuel efficiency, allowing users to mow larger areas without frequent stops for refueling.

The Stiga 8211-0276-08 boasts a cutting width of 42 centimeters, making it ideal for medium-sized lawns. The precision cutting blades are designed to handle various grass types and thicknesses, ensuring excellent results every time. Users have the option to adjust the cutting height, with settings available from 25 mm to 75 mm, allowing for personalized lawn care depending on the season and grass growth conditions.

Another key characteristic of this mower is its lightweight design, which contributes to easy maneuverability. The ergonomic handle provides comfort during operation, reducing fatigue during extended use. The mower is designed with user-friendly controls, making it accessible for both novice and experienced users.

The Stiga 8211-0276-08 also integrates advanced technologies that enhance functionality. For instance, the model features a robust grass collector that holds a significant amount of grass clippings, reducing the need for frequent emptying. This not only saves time but also allows for a cleaner mowing process. Furthermore, the mower's rear discharge feature provides the option to leave clippings on the lawn for additional nutrients, promoting a healthier grass environment.

Durability is another hallmark of the Stiga 8211-0276-08, with high-quality materials that withstand various weather conditions and regular use. This ensures longevity and reliability, making it a sound investment for any homeowner looking to maintain a beautiful lawn year-round.

Overall, the Stiga 8211-0276-08 is a well-rounded lawn mower that combines power, efficiency, and ease of use. Its thoughtful design and premium features make it an excellent choice for anyone looking to simplify their lawn care routine while achieving professional-looking results.