Dorel 01-068 manual To Install Front Seat, To Install Canopies, To Install Trays

Page 5

4To Install Front Seat:

Face seat forward and align sockets on seat with brackets on frame. Push down until seat locks with a click.

To attach seat in rear-facing position, press red buttons on sides of seat to release locks, lift seat off brackets.

Rotate seat 180 degrees, align sock- ets with brackets and push down until seat locks with a click.

5To Install Canopies:

pin

Front Canopy: Align canopy tabs with sockets in seat sides, push down until locked. Note: Vent in canopy goes toward back of seat as shown.

Rear Canopy: The rear canopy comes partially installed over frame. To com- plete, canopy hinge brackets must be attached to stroller frame.

Snap canopy hinge brackets onto frame just below “armrests”, aligning hole in brackets over pins on frame as shown.

6To Install Trays:

pin

Parent Tray: From front of handle, insert tray between handle frame.

Align holes in tray brackets with pins on each side of frame as shown.

Gently pivot tray down until brackets snap around handle frame.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Thank You Table of Contents Do not Parts List Parts ListTo Install Front Wheels Assembly Instructions To UnfoldTo Install Rear Wheels To Install Trays To Install Front SeatTo Install Canopies Injury or death of your child To Use Using Restraint System Adjusting Harness StrapsShoulder Straps Waist Center Button As above To Recline Seat BacksTo Use Rear Seat as carriage To unlock, pull levers up To Use Front Footrest 12 To Use Rear BrakesTo Use Swivel Locks Put one end in first, then, compress To Attach Car SeatsBar to place other end into second Always use the restraint systemTo Remove Pads for Washing To FoldWarranty Limitations One Year Limited WarrantyTo Replace Pads after Washing Limitation of DamagesFill Out For Credit Card Use Replacement Parts Order FormReplacement Parts List
Top Page Image Contents