Assembly Instructions
1To Unfold:
Place stroller frame on end as shown. | Grasp handle, pull back and up | View of unfolded stroller. |
| sharply until frame opens and locks |
|
| with a click. |
|
|
|
|
2To Install Rear Wheels:
Push axle assembly onto frame until but- tons snap into holes on assembly. Make sure both sides are on completely.
1 washer
cotter
pin 
axle
assembly
hub |
| single |
|
|
|
|
cap |
| wheel |
| 1 washer |
| brake |
Remove protective packing from axle ends and discard. Remove Cotter pins and washers from axle and set aside.
Slide 1 washer onto axle so washer is against the brake. Put one of the single wheels onto axle with hub to the inside. Slide on another washer. Insert straight side of Cotter pin through hole in the axle. Align pegs in wheel cover with holes in wheel and snap on. Repeat for other side.
3To Install Front Wheels:
wheel
assembly
socket
|
| frame tube |
|
|
|
|
|
|
|
|
|
| Align front wheel assembly socket with | Push the wheel assembly onto frame | |||
4 | front frame tube as shown. | tube until it clicks into position. Repeat | |||
|
|
| for other front wheel. | ||
View of assembled front wheels.